| Thread | Last Post | Replies |
|
| crankshaft damper stuck with crankshaft sprocket | 05 Sep 2006 20:56 GMT | 19 |
Hi, I got an issue: I got a stratus es 1996 2.5 V6 AC. I need to change the water pump. So I'm @ removing the crankshaft damper pulley but the freaking thing
|
| Jeep Falls rolls down a cliff | 05 Sep 2006 16:38 GMT | 8 |
http://jeepgrandcherokeelimited.blogspot.com/2006/09/jeep-falls-rolls-down-cliff.html Jeep Falls rolls down a cliff
|
| police car wheel question | 05 Sep 2006 15:12 GMT | 7 |
I've got a set of 15x7" police car wheels on my old Studebaker, they are the ones that look kind of like Chevy Rallyes. Can someone tell me what size hubcap I need for these? I saw some on eBay that I would like to bid on if they will work, but unfortunately I won't have a ...
|
| Breakdown of the load circuit. Excuse my bad English, I am French. | 05 Sep 2006 15:07 GMT | 3 |
Chrysler voyager 2.5 l 1990 Chronic random breakdown. Occurs more in very hot or cold weather. I start and roll normally, and sudden check Gages and sometimes check
|
| Eagle Starter Problem | 05 Sep 2006 15:00 GMT | 7 |
I'm having a problem with my '95 Eagle's starter (Vision ESI 3.3; ND starter). Any time it's damp out (it seems) the starter solenoid will simply click and not engage the starter, or simply give a little half hearted crank. I took it out last week and had it tested. It didn't
|
| Stratus blower speed problem | 05 Sep 2006 12:54 GMT | 7 |
All of a sudden, the A/C-Heater fan in my 2002 Stratus has lost it's three slowest speeds. Everything works on high speed, but selecting the other three speeds shuts down the fan. I seem to remember reading that a "resistor block" malfunction could cause
|
| 1993 Intrepid random stalling | 05 Sep 2006 04:34 GMT | 11 |
Hi All, I have a 93 intrepid with the 3.5l engine that randomly cuts out on me. It doesn't fade like if its losing gas. Things I have done to it recently that have not helped Cleaned the throttle body.
|
| Parking brake light comes on occasionally | 04 Sep 2006 23:04 GMT | 13 |
The parking brake light on the dash of my 2000 Concorde LX comes on occasionally even though the parking brake is not engaged. The brake is a pedal and it's fully disengaged (pulled up) so the light is not do to it being partially pressed from what I can tell. Anyone have any ...
|
| 1999 Town&Country in limp mode, speedometer doesn't work | 04 Sep 2006 22:59 GMT | 6 |
My 1999 Chrysler Town&Country had some strange indications. The gear wouldn't shift up, the engine service light came on and the speedometer doesn't work. After searching the internet on a solution I disconnected the battery
|
| 93 Grand Caravan 3.0 V-6 Serpentine Belt--What tool to use ??? | 04 Sep 2006 16:17 GMT | 3 |
What tool (is there a specific name, where do you get one, what brand, etc.) do you use to change the serpentine belt? Thanks.!
|
| Anyone install "park assists" (backup sensors) on their car? | 04 Sep 2006 14:13 GMT | 3 |
I just bought a used 2000 Chrysler Concorde. Nice car, but rear visibility is really bad for judging where the bumper is. I'm considering installing backup sensors of some kind. Has anyone here done this and found them successful? Difficult to
|
| Monroe Quick Struts | 04 Sep 2006 14:11 GMT | 2 |
Has anyone installed these themselves and if so what was your experience. Easy as they appear to be?
|
| Remote Trunk Latch on Concorde not working... | 04 Sep 2006 14:06 GMT | 5 |
I have a 2000 Concorde and the remote trunk latch doesn't work. Doesn't click or make any sound at all. Neither the internal dash button, nor the fob button work. What's the most likely cause of this problem? Thanks.
|
| Idle | 04 Sep 2006 06:38 GMT | 2 |
I have a 2000 Crysler Sebring Convertible. I just had to have all of my valves replaced due to a timing belt that jumped and caused damage to them. I just got it back today and after having it for a couple of hours it started idling at about 1500RPM's. It jumped all the way to ...
|
| Replacing '96 LH Engine Cradle Front Bolts | 04 Sep 2006 05:52 GMT | 4 |
I have an 85K mile, 11-year old, 1996 Eagle Vision TSI (LH Body) that is still running pretty well. When underneath to change the oil, I noticed that the nuts on the two front bolts holding the engine cradle to the body/frame are severely rusted. (The two back bolts and nuts ...
|