| Thread | Last Post | Replies |
|
| 96 Grand Caravan Blowing Ignition Coils | 29 Jun 2007 21:51 GMT | 3 |
I have a 96 Dodge Grand Caravan 3.3L V6 w/ 140K miles. Engine suddenly began running rough, check engine light came on, and vehicle stalled after another minute or so. Mechanic replaced Cam Sensor and Ignition Coil. Vehicle started up and ran fine for about five miles
|
| Chrysler Magazine | 29 Jun 2007 20:41 GMT | 40 |
Chrysler Magazine is looking for owners to feature in the publication. Must have a unique story about car, job, life, etc. and be enthusiastic about your Chrysler. Please send information for consideration to Kristin.Appenbrink@meredith.com. Thanks in advance for your help.
|
| Bolt ‘N Go™ COMPLETE FORD 9” & GM 12 BOLT CRATE REAR ENDS | 29 Jun 2007 17:48 GMT | 1 |
HOUSINGS INCLUDES: • Moser 31 Spline Performance Axle Package • TrueTrac® or Detroit Locker® Differential • Richmond Gear ring & pinion • Timken bearings
|
| Caravan Antenna Access | 27 Jun 2007 21:34 GMT | 1 |
I want to gain access to the cable on my external antenna on the passenger fender. Do you have to remove the wheel well splash shield? I am installing an XM satellite system and need to run a small coax from the external antenna back to the under side of the dash. I'm
|
| 95 dakota transfer case issue!!!!!!!!!!!! | 27 Jun 2007 20:27 GMT | 4 |
I read the manual to remove the transfer case and it says to remove the rear crossmember. I have a 95 dakota slt ext cab 4x4. Problem is , the rear crossmember
|
| 3th seat in the front. | 27 Jun 2007 01:27 GMT | 2 |
What is the right name from the little seat between the front seats in a Voyager automatic. Can I buy some seat with seat-belts? Is it made by Chrysler? For searching the web I need a name for it.
|
| brakes dragging | 26 Jun 2007 15:45 GMT | 5 |
1999 Plymouth Voyager 2.4L The front brakes wore out prematurely because of dragging. I replaced the rotors and the calipers. A few months later, they're dead again. To be fair, my wife has been delivering pizza out of this van, but it's
|
| rec.autos.makers.chrysler FAQ, Part 1/6 | 26 Jun 2007 05:26 GMT | 2 |
Archive-name: autos/chrysler-faq/general/part1 Posting-Frequency: 15 days Last-modified: 2007/5/15 Version: 6.0
|
| 1988 Eagle Premier ES | 26 Jun 2007 00:19 GMT | 3 |
Hi my name is Mike and I have an 88 eagle premier my speedometer & odometer are not working anymore but the odometer & trip was woking for a year and the speedometer was not working the rest of the guages do work like temp, gas, oil pressure, etc. Please some1 help me out
|
| 2001 PT Cruiser A/C @ idle Problem | 25 Jun 2007 20:43 GMT | 9 |
My 2001 PT has just started a strange thing a week or so ago. When I start the car and it is at idle and turn on the A/C the system seems to cycle the compressor on for a few seconds. No more than ten. Then it is off for about 30 seconds and cycles on for several seconds and
|
| Lump in Idle; 01 PT Cruiser | 25 Jun 2007 18:04 GMT | 13 |
My beloved PT Cruiser with about 90,000 miles works to perfection; almost. With the air running I experience a serious lump in the idle, perhaps once per sec, or so. With the air off, and the car in or out of gear the lump is mostly gone, at least not noticeable. Yes, it has new ...
|
| '96 6-cyl. Stratus starting problem | 25 Jun 2007 15:13 GMT | 4 |
Over the last few months our 1996 V-6 Stratus ES has occasionally been difficult to start after standing for an hour or two (but never after standing overnight, IIRC). The engine cranks over at full speed, but it does not "catch." After leaving it alone for a while, however, it ...
|
| a/c ? | 25 Jun 2007 13:16 GMT | 1 |
hello , i have a 1998 dodge stratus and am hearing some kind of hissing noise inside the car, near the heater and a/c controls. now my a/c doesn't work and until this noise started it was ok ,but i had to recharge it last summer. any ideas or what i should look for and how hard ...
|
| 99 Stratus 2.5V6 Tune Up...Is it a Pain? | 25 Jun 2007 03:12 GMT | 3 |
Car is getting close to 90K miles and was wondering how bad it really is to change out plugs and wires on this car. Looks like the upper intake has to come off, and all the other gadgets attached, but other than that looks pretty straightforward.
|
| Inner CV shaft retaining circlip | 24 Jun 2007 17:48 GMT | 2 |
[this is a follow up to my previous posts about wheel bearing/knuckle/ cv shaft replacement on an '01 Chrysler Concorde] The new CV shaft I got came with a very flimsy circlip -- it was much softer and thinner than the OEM one that was on the stub shaft.
|