The bushing(s) on the front stabilizer have failed 4 times since 2001
(new). Any ideas?

As some of us may know Chrysler will start cutting jobs and production
starting later this month.
that means that over 10,000 people will soon be unemployed and IMO i
blame the company for not keeping up with the Jones's,like Toyota,

A couple of weeks ago during a cold snap (-20) I noticed a puddle of
antifreeze under my van. It appeared to be from the drivers side of
the radiator, but I can't see any leak, etc., and everything seems ok
now. I added about a quart of antifreeze to the reservoir (It was

The small and light, yet reasonably roadworthy Smart Car would seem to be
ideal as the auto component of a practical car-plane.  The auto half has
always been the weak half of the equation particulary in recent years due
to emissions and crash standards. Only minimal alterations in ...

Archive-name: autos/chrysler-faq/general/part1
Posting-Frequency: 15 days
Last-modified: 2007/6/26
Version: 6

I have a 99 Ram Van 1500 3.9L.  The blower only runs on high speed so
I'm looking at replacing the motor resistor.  The Haynes manual says the
resistor in Dodge vans is behind the glove compartment.  Is this right
or wrong? I looked at two different resistors from the parts store ...

A friend of mine is working for Al Qaeda and he's looking
for a car for a suicide mission.
Is a Chrysler good for that purpose or do you recommend
some other car???

I was cleaing out my trunk tonight and took off the tire floor cover to
clean around the ridge and noticed condensation on the spare tire as well as
the lining was damp.
Any idea on what happened? or is happening?  I haven't hauled anything in

I'm starting to do my research on this car and anxious for any user
feedback or tips (to do or to avoid) before I pull the trigger. I can
easily wait 2-4 more weeks before purchasing this or any other
vehicle.

I have a 1994 Dodge Caravan with 240K on it. It recently developed a
low speed idle problem, where the vehicle would almost stall. It was
OK at startup, but once it warmed up, the engine would idle below 500
RPM, and cycle between 400 and 700 rpm rythmically. After cleaning the

I am having problems with my HVAC system. I know the power and recirc
button trick to recalibrate but it is too cold, I think, to get it to
perform currently. (I read somewhere that ambient temperature has to be
50ish degrees.)