My power steering system on 02 T&C was making some noise, I had the
system flushed, the noise is gone and it is working just fine.
Now the end seal of the rock is dripping about one drop of fluid each
day, can I use some power steering additive to soften the end seal and

My 04 Town & Country's reverse lights no longer function. The dealer said it
is a defect in the body computer. This is very expensive!
The question raised concerns the use of a used body computer. Dealer says
that once it is programmed it can't be reprogrammed by the dealer. Does ...

I need to buy a battery to temporarily start and move a car so I might
as well buy one that will fit my 300m.
The battery that is currently in my '00 300m is the original battery
(8 years old now) and although it seems fine now, it may not last

Over the past few months my '00 300M has developed a bit of an exhaust
bark.
I had an oil change today (at a Midas dealership, first time ever that
I've not had it done at a Chrysler dealer) and I asked them to look at

What would cause low oil pressure on a 1999 Dodge Dakota,125K miles. Oil pump
and pressure regulator replaced?  Pressure is erradic, as it reads 60 psi for
awhile then drops to zero.Sending unit replaced but continues to have the same
problem. What gives???

I have a 1994 Dodge Dakota SLT V8 5.2L. 5sp. It started to die when
driving and after sitting for a little bit (1/2 hr) started back up
again and
ran for a few more days.

why if i had a catalytic converter changed would my engine sound noisier
under the hood  and also in the drivers compartment?

This has been an ongoing problem with my 98 dodge stratus for five months.
This experience with this car proves to me why I never want to take my car
to a mechanic unless it's absolutely necessary. Five weeks and two mechanics
later, who were both highly recommended, my car still ...

I have a 1994 Dodge Dakota SLT V8 5.2L. 5sp. It started to die when
driving and after sitting for a little bit (1/2 hr) started back up
again and
ran for a few more days.

My transmission( 75,000 miles)  makes perfect 1-2 shifts when the
throttle is pressed down making moderate or significant acceleration.
However, if i'm just going slow and the 1-2 upshift occurs there is some
slippage or vagueness experienced in the shift. There is no clunk felt

Archive-name: autos/chrysler-faq/general/part1
Posting-Frequency: 15 days
Last-modified: 2007/6/26
Version: 6

2000 GC with typical hard shifter actuation from the column.  Thought it
might be the cable, since it was rusty & was original shift cable. After
disconnecting the shift cable at the transmission, I tried to rotate the
shaft by hand, but could not move it at all.  Thought vehicle ...

My 1991 LeBaron is having an issue where the Check Engine Light will
come on evrey 5th, or 6th HOT start. It never comes on on a cold
start, and only ever so often will it come on after a HOT start.
Codes are 12, 22, 55.

I just picked up a '71 Cuda w/340 3spd. However, the carb is
missing...does anyone have any info on exactly what carb I should look
for ? TIA
Jay

I was driving the car when it started smoking heavily so I pulled
over, the temp was fine but then the car sputtered pulling into the
parking spot and died, also some weird fluid seemed to be leaking but
well get to that later.