| Thread | Last Post | Replies |
|
| C5 suspension | 31 Mar 2005 13:03 GMT | 1 |
Hello to you all, I bought a C5 estate about 4 months ago, When it was parked over night, the suspension did not sink right down, (as all my other Citroens have done), so i thought it was a characteristic of the new 'Hydractive' suspension. Then i started to hear squeaking ...
|
| Xantia Rear Suspension sunk | 30 Mar 2005 22:26 GMT | 6 |
I have a 1.9 turbo Diesel Xantia (P reg). The back suspension has sunk as if the lever has been set to the lowest setting. The front suspension works fine. If I put the lever to the highest setting the front end rises, followed by the rear. Now If I set
|
| Citroen Xsara 1900 diesel | 30 Mar 2005 20:28 GMT | 1 |
i need some information about Citroen Xsara 1900 Diesel (year 2000). Is this a good car? And about engine? I'd like know it's consumptions ratio. Thanks, luca
|
| RPM Meter installation | 28 Mar 2005 17:48 GMT | 2 |
Can anyone advise or provide any schematic diagram to install an aftermarket RPM meter for the Citroen Jumpy 1.9D ? The Jumpy van comes with a stupid big face clock right beside the speedometer. Imagine most of the renown mechanics and motorshops here in Singapore dun
|
| Citroen Xsara Service Reset | 27 Mar 2005 15:21 GMT | 2 |
Does nayone know how to reset the service tool message on a Citroen Xsara Phase 1? Many Thanks Paul
|
| Berlingo Handbook | 26 Mar 2005 18:00 GMT | 1 |
I recently bought a new Berlingo Multispace with the 2L HDi engine. All going well, but I was surprised to find that Haynes don't do a manual. Any suggestions as to where to find one? Is the engine the same as used in another Citroen?
|
| C2 beam deflectors | 24 Mar 2005 23:48 GMT | 1 |
Bit urgent this one... and Citroen don't appear interested in helping (again...!) Need to know where to put beam deflectors on my UK (RHD) C2 for use in Europe - it's urgent because Citroen were supposed to send me a fax
|
| Xsara keys query? | 24 Mar 2005 12:57 GMT | 5 |
Here's hoping this is the right place to ask this question...... I have just purchased two Citroen Xsara's in the UK. One is an LX on a 51 plate and the other is a Desire on a 54 plate. I got two remote access fobs with the 51 plate but only one with the 54 plate. I asked
|
| XANTIA DIAGNOSTIC SOCKET | 23 Mar 2005 17:58 GMT | 5 |
Can anyone please tell me where the green 2pin diagnostic socket is located on my Xantia Please. i have bought a fault code reader & i have no where to put it!. i know where i would like to put it. thanks in advance
|
| Lubricant grades: engine oils | 20 Mar 2005 21:55 GMT | 1 |
Trying to avoid longish trip to the "local" Citroen garage, and the cost of the Citroen-recommended Total product, I got the local motorist's shop to obtain some 5W-40 oil for my C3 diesel. Yes, it is indeed (synthetic) 5W-40, like the recommended Total Quartz
|
| Drive belt query | 17 Mar 2005 19:32 GMT | 7 |
I've just had my 5 year old Xsara serviced by Halfords/AA/National, I asked about the drive belt getting renewed and they tell me it doesn't get remewed until it is 10 years old. Is this correct. A colleague tells me it's usually 5 years. Any help appreciated
|
| warranty claims | 17 Mar 2005 16:53 GMT | 1 |
anyone know the situation re warranty claims for a broken seat ? it's a C8 and all the seats should fold and tilt forward, one seat made a loud crack when tipping it forward and no longer works properly, can't even get it out only tip the top forward.
|
| Wipers failed | 11 Mar 2005 17:48 GMT | 3 |
During recent cold spell the wipers on my C3 failed. I have checked the fuse and that has not blown. I cannot here the wiper motor running. Can anyone please help
|
| New Car | 11 Mar 2005 09:00 GMT | 3 |
i recently posted info on my 96n xantia td. saying it wasn't too well.. having spent a few hundred pounds on it. it realy does drive like a new car. i had test driven a few newer cars adn i must say none of them came close to this now.
|
| Removing Xantia door trim | 08 Mar 2005 22:44 GMT | 4 |
I have a '00 Xantia Break, and can't figure out where to start, in order to remove the trim panel. I can't spot a single screw or bolt to provide me with a starting point. Please help. Regards,
|