Sunny, 74 degrees, NASCAR is back and the Cardinals are in spring
training...... <sigh> life is good!
;^)
Mike

I have a 99 Ram 1500 and recently the ABS as well as the parking brake
light came on. Not sure if this was a coincidence or a related
problem. What does this mean and what do I need to do to address this
problem or occurrence?

99 dodge caravan, 4cyl 3 speed auto.
Won't shift into reverse unless warm.
Has trouble shifting into 3rd anytime (slips).
If let off gas it *may* shift into 3rd.

97 DODGE DAKOTA, EXT CAB. 4x4,V8,AUTO,
Any ideas what is causing, how to fix? what appears to be rear end noise,
gets louder with speed, but does not change pitch, same loudness when
coasting in neutral, does not appear to be axle bearings, or tires or brake

Check Engine light has been on for about 2 months, got it checked out when
it first came on at Autozone. They said, the code reflected a small
(minor) fuel system leak, perhaps a faulty gas cap (replaced and reset
check engine light) or a vacuum leak. Well the engine check light is ...

Well, I replaced the trans fluid and filter, and the kit
came with a rubber pan gasket - so I RTV'ed the gasket
to the pan, ran a bead on top the gasket, and torqued
it to specs.  Road test - no leaks.  Next morning ALL the

Recently every time I start my 2001 Durango RT the horn honks one time.
If I open the door with the engine running and then close it again the
horn honks. When I shut the engine off and exit the vehicle the horn
will honk either when I close the door or anywhere from 2 to 15 seconds

I replaced all the bearings in my Dakota axle 2 years ago now its making
some noise again, mostly on a
right turn. I suspect the left carrier bearing, any thoughts? I did`nt have
a adjusting. spanner or other tool or torsion bar to adj. preload properly

I have a 1989 dodge ram 50 that I would like to convert over to the
weber carb and eliminate all the vacuum hoses that run to the orginal
carb, except for the distributor advance. Wonder if any of you have any
experience with one of these convesion kits?

Im searching for all the required parts to swap a 360ci for a 413ci in a
1982 350 Power Ram. A bellhousing, flywheel, and a bb electronic ignition
distributor.  If you have any info on these parts, many thanks for your
time.  Fyrfly

98 1/2 ton auto 4x4 318. Only way to get back up lights to come on is to
hold shifter between park and rev. Just got the truck a couple of weeks ago
so haven't had achance to hunt for the problem yet. Any ideas? Thanks

I have a 2001 dodge ram 2500.I couldn?t find the drain plug for the
radiator.Does it have one or do i remove the lower hose?
                            Ronnie

I am playing around with rss feeds.  I registered a domain name www.rssdaily.com
and started coding in it.  It's pretty interesting using rss and xml.
I am pulling feeds from all sources and also search rss feeds from yahoo and msn
Take a look and give me some feedbacks.

Simple question I think.  I thought everything made after 1996 was
ODB2 but I found at least one website that says my 97 Dodge Ram 1500
5.2L is a ODB1 vehicle.  Anyone know for sure?  Where's the connector?
Will the connector type tell me for sure?

A friend at work and myself  each bought an 04 Hemi.  He has noticed what he
believes to be rust on his rear bumper and I believe I have it too. I have
seen this discussed on the Dodge Truck World Forums and it seems to be a
common problem. Anybody else notice this?  Hopefully ...