Home | Contact Us | FAQ | Search & Site Map | Link to Us
Sign In | Join | Other 45 Sites in Network
HomeAnnouncements
Discussion Groups
By Brand
BMWChevroletDodgeFordGMHondaLexusMercedes-BenzNissanPeugeotToyotaVolkswagenOther Brands
By Topic
4x4 CarsRVsDrivingMaintenance & RepairCar AudioCollectible Cars
Country Specific
Australian ForumsUK Forums
ArticlesAuto InsuranceBuyingCars & TechnologyMaintenanceMiscellaneousSafety
DMV Resources
Related Topics
MotorcyclesBoatsMore Topics ...

Car Forum / Dodge / Dodge Trucks / November 2005

Tip: Looking for answers? Try searching our database.

ThreadLast Post  Replies
7-way connector wiring26 Nov 2005 23:02 GMT5
The 7-way connecter on my 05 Ram 2500 does not have power on the
positive pin in ther connector. As such I get no charging of my trailer
battery when I am hooked up. What gives? What do I have to do to get
this pin powered?
2001 Dodge Ram 2500 wiring diagram?25 Nov 2005 22:18 GMT1
The link below does not go back as far as 2001. Any idea where to get
2001 wiring diagrams?
Thanks,
Charles
let's try this again.....25 Nov 2005 15:12 GMT3
If this is OT, I really apologize.  I'm looking for a project truck.
Basically, I'm looking for:
1.) 1990-1998
2.) 250/2500
92 dodge dakota rare overheating25 Nov 2005 08:29 GMT9
My dakota is recently overheating since i installed a new thermostat, it
ran perfect all summer without a thermostat, i replaced the radiator,
water pump and all of the hoses, when my heater is blowing hot air the
truck does not overheat,but as i am driving the blower all of a ...
Closure: 01 Dodge 24v Diesel lift pump pressure25 Nov 2005 05:25 GMT5
First, thanks for all your help and advice.
To recap, I recently bought a 2001 Dodge 24V quad cab long bed TD. I had
a pressure guage installed on the lift pump to monitor pressure. It was
installed between the lift pump and filter. It registered around 7.5 psi
Durango Calipers25 Nov 2005 04:51 GMT4
Last time I replaced the brakes/rotors I noticed chips of ceramic falling
out from the pistons on the front brake calipers of '99 4x4 Durango.  Can
they be rebuilt or should I replace the whole caliper. I'm getting ready to
do another pad/rotor replacement and figured this would be ...
Grinding Noise24 Nov 2005 01:54 GMT4
I have a 97 Dakota. When I shift from park through Neutral to drive there is
a momentary grinding noise. Any ideas as to what this might be. I would
equate the noise to that of accidently cranking the engine while its
running. Thanks
Negative oil pressure??24 Nov 2005 01:50 GMT1
92 318 Dakota 90K miles
Just started noticing this on cold mornings.  When I first crank it up
the oil pressure guage dives below zero, as far as it can go. It stays
there 4 or 5 seconds then begins climbing towards normal.  
Aftermarket Cold Air Intake for 99 ram sport 1500 360ci24 Nov 2005 00:04 GMT1
Everything I find is in the 150 - 200 doller range   anything cheaper out
there?
seatbelts23 Nov 2005 06:27 GMT5
re:5 Ram
I drive 8 blocks to work, I am the only vehicle out in this town at the
time, I always wear my seat belt, except this 20 mph drive to work.
Any ideas on how to quiet or stop the irritating dinger without a seatbelt
door locks23 Nov 2005 03:58 GMT2
I have shut off the auto lock feature on the drivers door,
but the other three doors are still locking -
which is very irritating!
Ideas on how to stop the auto lock completely?
Help replacing TCC on Dodge Caravan23 Nov 2005 03:08 GMT2
Anyone got any ideas on how to get into the TCC on a 95 dodge caravan, the
guides and books that
I have are useless, if anyone can make any suggestions I would be really
grateful.
gauge readings erratic22 Nov 2005 14:53 GMT12
I have a 91 Dodge W250 with the Cummins diesel engine.  Recently I
experienced some air in my brake lines and when I pressed the pedal to
the floor my emergency brake and anti-lock brake light on my dash lit
up.  I bled the brakes but the lights on my dash stayed lit (except now
2001 Dodge Ram 1500 3.9 V6 magnum22 Nov 2005 13:17 GMT5
I really do need instructions on how to replace the serpentine belt on
this.
I would appreciate any help on this matter.
01 Dodge Diesel Lift Pump Pressure?22 Nov 2005 03:25 GMT13
I picked up my truck today, 2001 2500 TD 24 valve after having EGT and
fuel pressure gauges installed. At idle, fuel pressure is like 5-7 psi,
it "hunts". While driving it is around 3 max, going up a hill (truck is
not really trying) it can drop to 1 or 2 psi.
Pages: 1 2 3 4 5 6 7 October, 2005
 
Sign In
Join
My Latest Posts
My Monitored Threads
My Blog
My Photo Gallery
My Profile
My Homepage

Start New Thread



©2008 Advenet LLC   Privacy Policy - Terms of Use
This website includes both content owned or controlled by Advenet as well as content owned or controlled by third parties.