Could use some help here.  Live in San Diego CA & cannot find one
dismantler/tow yeard with the parts I need. I'm on a coupla email
lists, Ecology Auto's inventory request list, ec.
This is what I need:

I'm getting ready to sell my '86 Dodge 1/2 ton p.u. to my brother and I go
out to find that the blower will only work on high speed now. It has a four
speed swithch. The vacuum operated louvers for various functions works fine
and directs the air where it's supposed to be and the ...

I hope everybody had a great holiday.
Based upon some recommendations from the group, I finally got around to
fixing the tranny in my 2002 Dodge 3500 4x4 with the CTD.  The thing was
either starting out in second gear, or getting stuck in first gear.  I

I was trying to remove the dash trim bezel around the radio and figured I had
better ask before breaking it.  I thought it was just held in by snaps but it
does not want to release. Does anyone know the secret of getting it off?
Thanks,

Merry Christmas to all!  I have a 04 2500 Cummins auto 3.73 with 25k.
It has never really run up to snuff.  Recently, the dealer found a
problem with the transfer pump letting air get in the system.  He
replaced it with an in-tank pump and that has helped.  However, it

I have a 1999 Durango, 5.9l, 4x4, SLT and need to find either a
replacement PCM, or a mopar performance or other compatible pcm for
this vehicle.  I had been holding out hoping that the older Durango
pcm's would begin to fall in price but it looks like that is not in

Over at mom's for Christmas. I get into a discussion with brother-in-law
about how worthless the my Cummins 4x4 was in mud due to the heavy front
end. he has a 05 Chevy 4x4 z71 that is more technology advanced than my
outdated ram. Well my pride was under attack, by a Chevy gasser ...

I have a 2004 Dodge Ram 1500 quadcab with 5.7L Hemi.  It has a free flow
exhaust muffler and a K&N air filter which replaced the original filter.  I
purchased a Hypertech programmer III and after using it I have not noticed
any increase in performance.  What are some of the ...

I have a 2003 Ram 1500.
The radio will not turn on.  I checked the wires and I have good ground
and the positive ignition switched wire turn 12v on and off.  I do not
have a constant 12v power wire though it's just dead.  I checked the

My Dodge Van has an intermittent problem. I start the engine and then try to
move and the engine does not respond  to the accelerator. It is a dodge 3500
with a V8 2001 model. When I restart the engine it will perform in a normal
manner. Any ideas?

Merry Christmas to all you AADT folks and your loved ones. Remember to drive
safely this weekend and not mess up the Holiday for anybody else, and for
that one AADT fellow with 'da machine' (you know who you are), may something
better come your way before you wear it out (or it ...

I mentioned in an earlier post, the intermittent Crank Sensor errors I was
receiving. The first fault occurred when I installed a Banks Kit. My first
thought was either the Banks kit or something I invertently did that caused
it. It was very intermittent. I double checked ...

We're putting a new radiator in my son's 98 1500. The lower
transmission line that enters the radiator has a stange connection that
I can't figure out how to remove. Is this a quick-connect fitting? How
do I get it off the old radiator to put on the new?

I replaced scored pinion bearings and set the pinion up ok. My problem is
when I adjust the backlash. Everything goes fine until I torque the
adjusters to 70ft lbs., with the brng. caps tightened to 100 ft lbs. Then
the bearing cups will not stay in position, they push in and lock ...

How do I reset the check engine light on my 2001 Durango? I think the
gas cap was left loose again, this happened once before and a shop
charged $50 to check for codes and reset the light. Can I just
disconnect the battery? Also, any suggestions for a scan tool since the