I bought a 2003 Ram Van 1500 recently and I'd like to get seat covers to
protect the vinyl on the bucket seats. Every bucket seat cover I've looked
at has a flap that is to be pulled through the gap between the seat and the
seat back. In my truck there is no such gap, however. ...

Ok, reposting renamed as my title didn't really match my post...
One of the fun bits about owning a strictly American vehicle overseas is
the availability of parts.
Been waiting two weeks to get tie bar ends.  Finally arrived, along with

Got it changed at last!
First they gave me the wrong one, the transmission one... then they didn't have
the right one... got a refund after 2 days..
Checked every place around, most places listed the rear sensor but couldn't get

how can i get rid of and diagnos the engine light?

I have a 92' power ram 150 with the 318.  I'm thinking about getting a
set of headers to go on it.  I have dual exhaust with the flowmaster 40
on it and it sounds pretty darn good.  What kind of a sound could i
expect with headers?  I'v read that you gain a little power and gas

OK, what's good?
Circuit City has a sale on the Garmin C330 for $399. How's it compare to a
Magellan? For that matter is the C530 ($200 higher) really worth the
difference?

I'm installing a lift on my 4x4 '04 Ram 1500. Instructions and service
manual call for a special tool: #8682 to remove the bushings in the
frame that hold the lower control arm. My question is do I need this
tool if I'm not re-using the bushing? The kit has bushings

It's been few years since I have taken part in your groups, Since then
I have bought myself 2002 KJ Jeep Cherokee Limited (Thats what they
called them in Australia) and (Australian Made) 1979 CM Chrysler
(Valiant) Regal SE with Hemi 6 265 ELB as cheaper option (when new)

Where can I find the fuse for the windshield washer on a 2000 Dodge Ram
2500 CTD.
The wiper fuse is good and the wipers work fine.  The washer did work
and now nothing.  It was about half full so I filled it up but still no

Can anyone tell me the difference between the 2006 Ram 2500 and 3500 (
both single rear wheel)?  I'm looking at buying one of these to pull my
horses.  The dealer suggests we should buy the 2500 because it has the
exact same specs as the 3500 except that the 3500 has one more set of

... but I've been surprised what "normal" is before.
I have a '97 Ram Van B2500, standard AC (front only). Under idle or
cruising conditions, all is fine & ac comes through the dashboard fairly
strong (might need recharge).

Any opinions welcome. I'm hoping those of you here have some insight
for me as to which might be the better choice. First the basics - 2006
Ram 2500 QC 4X4 CTD with 3.73 limited slip rear diff. Towing 30' Jayco
TT plus lots of gear - say 8000# total in addition to the truck.

Is there a common problem with rear axle failure on these beasts???
I have a 1998 QC 1500 with the chrysler 9.25 rear axle and it started a howl
about a month ago. I can only turn the radio up so far!
Took it to the tire shop and had the tiresbalanced and rotated (for free,

My 2001 Dakota 4.7L 4x4 seems to 'want' to downshift at odd times. It's an
automatic transmission. It almost feels like the brakes are being applied.
The 'braking' lasts less than a second. Seems to occur when I am coasting
downhill and I'm moving around 40-45 mph. But there's no ...

Looks like I have to head south again. Wondering if it is worth jumping off
695 and on to 97 just south of Baltimore and then going into 301 and so on.
Figure it might be a change. Any thoughts?
Roy