hi there, the u joint on my 4 wheel drive is going out. a mechanic told me
there is a bearing there that can rarely be removed and re-used because of
such a close fit tolerance. cost of a new bearing is $250.00 to $300.00.
does anyone know how to remove this bearing so it can be ...

Hey all, what is a good source for aftermarket pickup bumpers?

Ok.  So today's big learning experience is that the 12v truck fridge
pulls power even with the switches are all "off".
So, I had a very dead truck this afternoon (2001 Dak).  No worries, I
have a very helpful neighbor with one of those portable jumper boxes.

2000 Dodge ram 1500 4x4
shifts from 1st to second at 14 mph ok
2nd to 3rd is a problem.
If I let off the gas at 30 35 mph it will shift but the rear end bangs.

Per the manual, I removed the: webbing between lens and truck frame; three
bolts holding lens assembly to body.  The assemble would not come out
freely.  I was worried about "forcing" the unit, fearing I might damage it.
I did manage to replace the right (passenger side) bulb by ...

I've got an '06 Dodge Ram w/ Cummins engine.
When I start my truck and run it for the first few miles, the headlights
seem to dim a bit, then go back to bright, and dim slightly, then bright,
etc.

Hi Folks! I am trying to determine the best way to hook up a set of
running board lights to the interior lighting wiring harness. These
fandangled vechiles are getting that much more difficult to pry apart
anymore....so thought I would throw the question out there before I

Yes !:  Why don't check it at: Truck World News...
No ! : Why don't try it at: Truck World News
We beg your comments

This is probably the same for all Dodge 2500's as it looks like the fuse
box is designed for multiple applications.
My trailer power at the 7-prong plug is always hot. It should only be on
when the engine is running. Under the hood on the driver's side (USA),

Got a '96 2500, Cummins, 4x4 and I'm having some steering problems.  The
truck has far too much play in the steering.  The truck will grab
imperfections in the road and pull the truck along those imperfections.
Reminds me of a vehicle with bad ball joints.  Has made for some

i fixed my fuel guage today, there is a elec pump in the tank, & the lift
pump on the engine?

I have 2 older dodges and 2 newer Jeeps that use G05 coolant.  One dodge is
a 98 Ram and the other is a 94 shadow.  I want to make things simple but
some times you can't.  Can the new G05 be used in older vehicles?
Coasty

I had a flipout sunroof installed over the summer ,they cut the dome light
out ,which i think went to the third brake light that is not working .Since
there is know wire in the  head rest how would i get power to that top brake
light ?????

.....when my truck is plugged in?  with winter moving in its starting to get
cold in montana, and its time to start plugging my truck in.  this also
means some hunting trips in -20/-30 degree weather where ill need to plug
the truck into the generator and im wondering what else ...

Edge EZ for 2006 Dodge RAM 3500 CTD Automatic transmission.
A Tech/Mechanic at the delivering dealer suggested an Edge EZ Power
Module for a small increase in mileage and 3 levels of power boost.  I
was told by the tech that while towing level 1 boot was OK, level 2 OK