| Thread | Last Post | Replies |
|
| molding | 08 Dec 2006 16:59 GMT | 1 |
Thanks Tom ,worked just fine ,much appreciated.
|
| 1990 Dodge Dakota | 08 Dec 2006 12:15 GMT | 1 |
It was runing fine when I stoped , when I tried to start it the motor will turn over but will not start.can someone tell me what to look for.
|
| Speedometer trouble | 07 Dec 2006 19:30 GMT | 6 |
Got a 92' Ram 150 5.2L(auto) 4x4. Last week the speedometer started not reading. Guy's at auto zone said it was speed sensor on the tranny, so i replaced it and still having trouble. Its works half the time. This past week it works every morning, but in the afternoon
|
| '97 Dodge Dakota Oil Pressure Drop when Warm | 07 Dec 2006 13:38 GMT | 7 |
From: "DJ" <spirithorsenospam@adelphia.net> Subject: '97 Dodge Dakota Oil Pressure Drop when Warm Date: Wednesday, December 06, 2006 12:30 PM '97 Dodge Dakota 4x4 5.2L
|
| Fuel Filter Cover | 07 Dec 2006 00:51 GMT | 3 |
Is there a certain torque spec in which to tighten the plastic cap on a fuel filter housing ? On my 2000 CTD, the cap is tight --snug plus 1/4 turn-- and when it is warm outside there is no problem but at night when it drops to the mid 20's I get some leaking around the top of ...
|
| odometer quit | 05 Dec 2006 22:16 GMT | 6 |
Speedo is still working but both the trip meter and the odometer have stopped on my 92 dodge b250 van. Anybody have any ideas? beekeep
|
| Left blinker going twice as fast as normal | 05 Dec 2006 20:17 GMT | 17 |
Everyone, could use some insight here. 2000 ram 1500 truck, left signal is clicking (and flashing) twice as fast as normal, right signal is normal speed. I know this "normally" means a bad bulb, but that didn't fix my problem
|
| Desperately need help! Truck stalled, won't start. | 05 Dec 2006 19:47 GMT | 2 |
We have a 1994 Dodge Ram 1500, 5.2 automatic. My husband drove 1/10th of a mile, put the truck in part to load something in the back. While loading items, it stalled and will not start. They tried putting gas in the carb, unhooking the MAP sensor,
|
| Why doesn't Dodge sell righthand drive trucks? | 05 Dec 2006 05:06 GMT | 7 |
'Cause I'm tellin' ya, from my experiences in England and Australia, they'd sell like hotcakes. I've only been in Oz for a few months, and I've had many conversations with Aussies about how cool they think my truck is (a 2001 Dakota SLT, 4x4, club cab, with a Line-X bedliner).
|
| is this normal 2004 cummins temp drops at idle | 04 Dec 2006 23:44 GMT | 2 |
I have a 2004 3500 cummins and live in Iowa. in the morning when its 20 or colder it takes abought 15 minutes at hyway speeds so 1900rpms befor the temp comes up to 200 is this slow for diesel? then when I get to work early and sit in my truck for 5 or 10 minutes befor
|
| Toyota cup car | 04 Dec 2006 17:39 GMT | 3 |
What label are they going to put on the Toyota cup car? Since they are using the Tundra label in the truck series maybe they could use the Tacoma label for the cup series.
|
| infamous "no bus" problem | 03 Dec 2006 21:21 GMT | 18 |
Ok, here's the deal: 1999 Durango, v8, 64k miles Intermittent engine + guage failure; odometer reads "no bus". The fix is, I go and press on each of the three PCM connectors and at some
|
| Trans Temp Sensor | 03 Dec 2006 20:50 GMT | 2 |
Where is the Trans Temp Sensor located on a 92' Power Ram 150- 5.2L(auto)4x4? Thanks
|
| stake holes on bed rail | 03 Dec 2006 06:12 GMT | 7 |
Got an older 12 valve 2500 with the stake holes on the top of the bed rail. I want to mount a fiberglass top on the bed so thought it would be a good idea to seal up those holes. What's the best way to do that??
|
| molding | 02 Dec 2006 23:06 GMT | 1 |
I have 2002 ram 1500 ,would like to take off black moldings on side of vehicle any suggestions ? Do not want to ruin paint
|