I have an '01 4x4 1500 quad cab with the short bed.  I was going to
tie something to the bed when, lo and behold, there are no front tie
down rings installed!!!  I'm gonna add some to the bed floor, but, I
was wondering, should there have been some, or is that stock?

WASHINGTON - District of Columbia officials warned a federal appeals court
Monday that its rejection of the city's handgun ban creates a precedent that
could severely limit gun control. A three-judge panel of the U.S. Court
of Appeals for the District of Columbia Circuit ruled ...

need help please
I travel back roads that have a lot of deer and other critters
crossing the road.I have already hit three deer.Is there a way to get
both the high and low beams on at the same time on a 2002 ram 1500.

I am amazed at the low quality writing skills of the average newsgroup
member.  People are incapable of writing complete accurate sentences.  Their
grammar is poor, and their spelling is just plain horrible.  Punctuation and
syntax are second thoughts.  Chatroomese seems to ...

I was just reading aarcuda's comments in another thread, and the "deuce and
a half" came to mind.  Also, the Jeep.
I Googled up the old deuce and  a half.  WOW, a whopping 104 horsepower!
And IIRC, the early forties Jeeps were 60 hp.

1. DRILL PRESS: A tall upright machine useful for suddenly snatching
flat metal bar stock out of your hands so that it smacks you in the chest
and flings your beer across the room, splattering it against that freshly
painted part you were drying.

Suddenly, without warning, jmc exclaimed (03-Apr-07 6:06 PM):

just a tad over 13mpg, and I was noticing today that it's lacking in
power too - used to practically create g-forces when I accelerate, now

Any of you folks heard or read about a anti-freeze break down? Seems that it
creates a ammonia like smell and a white gunk that clogs the water passages.
Been reading about it on a srt8 forum.
Roy

I'm coming up to my 15,000 mile oil change, and I figure my check engine
light will come on like it did for the first.
What's the sequence for getting the codes to display, for clearing them, and
what's a good reader that won't cost as much as a set of tire?

    The HD Dodge is being offered with a 5 speed automatic which
is a 545RFE. There's also an option for a 6 speed transmission which
gives no details other than an aux tranny cooler. the gentleman that
runs my truck shop just bought one of these trucks with the new

I went target shooting this morning and had brass slinging all over the
place.  First it was a Sig, then a Glock, then some 9mm I hadn't heard of
before.  Then out came the Steyr Aug A3 and the M4.  That was a load of fun.
The guy with the MP 5's didn't show up so we only had one ...

I really appreciate all the advice in this newsgroup - you pointed me
to some great sites, now I have photographic guides on how to do
everything from the plug wire re-route to replacing the timing chain
(not looking forward to that).

Today I Did My First Oil Change 18,000 km . The dealer has done one or
two before me.. i am using amisoil synthetic and a fleetguard filter,
are these any good?, my concern is that i found some metal after
draining the oil.. :( im not too sure because it is a new motor but is

http:spankthbank.org is for free credit repair.
http://mortgageconsolidationrefinance.com is for finance.
http://potoukian.com is da bomb for refinance  and consolidations!
http://elown.com is about credit repair and great mortgage deals. Word!

I was flipping through the channels this morning and happen to run across an
episode of Trucks or one of them shows on Spike and they were talking about
Nitrogen Gas.  Specifically they were talking about using it in tire, as the
molecules are bigger the O2 and a few other ...