On my new 2007 ram I found the blue connector under the dash.  However,
it's opening is right up against a large wiring harness coming from the
white plastic box that the blue connector is mounted to.  How the heck
is one supposed to plug anything into the blue connector when its ...

I have a 1996 Ram 1500 4X2, auto, 318. extended cab with 307K miles on it
and I need to replace or clean the heater core (it's the original core). I
can hear a noise that can only be from a clogged core. According to the
manual I have drain the A/C in order to replace it, plus it ...

I have an '04 3500 Ram with factory Towing mirrors. I broke the driver's
side mirror and have a replacement. The problem is how do I remove the
plastic molding to effect the swap without destroying it? Two of the 3
mounting screws are clear, but the top door molding is probably ...

I'm going to replce my front disc brakes on my 03 dakota. I'v worked on
mostly GM brakes, they use a allen head driver (?) to remove the pins. Are
these the same and what size?
      Thanks

Is there a common cause for this code?  It has gotten to the point
that within a day or so the code shows again after I reset the DTCs.
Was just wondering if you guys have seen it to be one thing more
than another.

I've found that I have some rust-through on my diff cover (live in
coastal New England). Can anyone point me towards either a retail
chain, or an online retailer, that would have a stock replacement
cover for the Dana 80? All I've seem to be able to find online are

Does anyone in this group have access to the DC computer that can
send me a "Build Sheet" for my Dakota if I send them the VIN?
TIA,
Tom R

I'd like to replace the belt on my '01 Ram (V6) and was wondering if
there are any problems or pitfalls I should know about before doing
so. It's squeaking a bit on cold starts and looks like it may be the
original with 90k on it. Thanks.

I need to remove the dash faceplate around the 6CD changer radio to
gain access to the antennae to install the traffic report module for
my Garmin. I looked quickly thinking it would be obvious this being my
5th Ram. This is a larimie w/ the wood trim around the radio. Thanks

I just replaced the O2 sensor on my van with a bosch replacement from
autozone. The old sensor was intermittant. When the old sensor was working,
I would measure about .4 volts with the engine at normal temperature. This
new sensor starts out at .5 volts cold, climbs towards 1 volt, ...

Just wanted to thank you guys for the reply on my 2000 ram that was blowing
a fuse.
I still could not find the problems so I went to justanswerDOTcom and a
dodge tech led me right to it.

I have a 06 dakota quad cab slt 4x4 with 4.7l engine with 3.55 limited
slip rearend.
Whenever the truck is warmed up there is a very noticeable clunk
whenever the truck is shifted into neutral or park from any gear any

i'm thinking of buying an 02 4x4 ram, slt with the sport package & was
wondering if theres anything i should look out for. it has 120,000
miles, one owner, & it looks mint. thanks for any info.
®

Question for the group, I have a 2001 Ram 2500 with a black decal
between the window and the door frame. This has started to peel and i
need some suggestions how to remove the whole decal without messing up
the paint underneath? Thanks for any ideas

So, I finally got the truck in to have the manifold gasket replaced (per
my posts a little bit ago).
Walked to the mechanic's this afternoon to find my truck still in the
shop with the hood up.  He was supposed to call if it wasn't ready!