I thought I could put in a engine block heater on a 97 dodge ram. I
removed the front freeze plug on the drivers side but there is not
enough room. The hole is the correct diameter, but it isin't deep
enough to install the heater. Should I have removed one of the other

Just joined the ranks of Dodge truck owner. Picked up a 2004 Dakota Quad Cab
SLT with 20,900 miles on her. Happy so far. I will be watching and learning
from this group.
Cecil

Anyone out there know which wires feed the speakers
in this trck?  I'd rather not have to remove the door
panels and be able to connect the speakers currently
installed under the dash.  I can go on and explain why

First of all, I know I could call a dealer but ever since I started
purchasing new vehicles waaaaaay back in 1966 I have only taken one back
to a dealer and was not impressed that time thus dealers are not my
first choice.

I've just spent the better part of two hours googling for an ABS Relay
for a 1992 Dodge Dakota (4 cyl, 5 spd manual, 2wd, no air conditioning).
I had no joy. Can anybody recommend a good online parts outlet that
would be likely to have that part?

I recently switched news servers. Is there an unusual amount of spam here
lately or is my new news sever not filtering messages like the old one?

My 2000 Dakota just started having this problem last week. When it sits for
6-8 hours it won't start. Turns over great spits a few times but won't fire
up. I remove the air cover and put some gas in the throttle body butterfly
and it starts right up and runs great, you then can ...

I have a 2001 1500 quad 5.9L 2 wheel drive 97k.  Dealer says upper and lower
ball joints should be replaced, grease seal broken and joints are dry and
worn.  Cost is over $2000.  He says the entire control arms need to be
replaced, just the ball joints cannot be replaced.  Does ...

I'm looking for a professional paint/body shop, preferably one that
specializes in Mopar or even e-bodies.
Anyone have any recommendations I can check out?

Hello group,
I have a 2005 Dakota w/ the 3.7L and automatic. I live in Minnesota and in
this cold weather my trucks really sucks the gas down, I get about 10.5-11.5
mpg. I was looking for ways to increase my fuel economy. I was looking at

I'm heading out Wednesday morning on a ski trip.  This will be the
first time I have taken my truck to such a cold place.  Weather is
supposed to dip and stay below 0F.
I live in Dallas, so a broad selection of anti-gel additives are few

Go to www.kncollision.net
Located in Columbus Georgia
Ken has been in business for over 30 years . expert painting , collision
repair , frame repair , restoration and much more. Ken is

I am sorry for posting this again. Forgot to mention that I am looking
for
the spark plug torque value.
The Haynes manual says its 30 Ft-Lbs and it looks a bit on the higher

Greetings form a new-be to this group.  I've a 02 Dakota 4 x 4 with the
4.7 ltr V8.  I'm thrying to get information on how to convert my truck
to burn flex fuels / E85.  I've tried Dodge / Chrylser, their only
comment was that it can't be done!  I believe there has to be some

Have and 1986 B250 full size van. Put in new tank - new sending unit.
Now it does not register on the dash gauge. I checked the ground and
power going into the sending unit When I check for power the test
light blinks steady. Is the steady blink what I'm suppose to be