| Thread | Last Post | Replies |
|
| 94 Intrepid Radio problems | 27 Jun 2005 18:10 GMT | 2 |
I just picked up a 94 intrepid... its in great running shape but I have a question about the factory radio.. Most of the time it is either completly dead (no lights, time, or radio) but I noticed just today that the time is lite up but does not change from 12:33 and still no ...
|
| plug size? | 27 Jun 2005 13:07 GMT | 4 |
What size lug socket is needed for the plugs on an 87 caravan 3.0 V6? I've got a 5/16, works great for my ivic, but doesn't seem to fit on the dodge plugs.
|
| 1994 Dodge Intrepid Mystery Problem. | 27 Jun 2005 01:26 GMT | 4 |
My 1994 3.3L Dodge Intrepid momentarily shuts down for about one to tw seconds when going up hill. No fault codes register. Tach freaks out cruise light comes on (no other lights), then car returns to norma operation. Had it in shop, put in another PCM computer, ASD relay
|
| timing belt 2000 Grnd caravan | 27 Jun 2005 01:09 GMT | 1 |
re: 2000 Grand Caravan... trying to figure out when, if ever, to replace the timing chain on above vehicle. The Shop Manual is pretty informative rE; 3 L engines, but it does not specify when to replace or even inspect the 3.3L. Currently I have no problems with the vehicle, but ...
|
| 1996 Dodge Grand Caravan LE-Tires | 26 Jun 2005 20:08 GMT | 26 |
Would it be unsafe to use P215/65 size tires on the front, and P215/60 on the rear? When I bought the van used all the tires were P215/60. Subsequently, I learned that the specified size is P215/65. Now, I need 2 new tires but I'm
|
| fuel filter or bad cap? | 26 Jun 2005 19:21 GMT | 2 |
hello, it seems if my 1998 dodge stratus sits for a few days it starts hard and misses for a while then when it finally warms up it runs great. also i noticed when it's damp it starts and acts the same until it's run a while. i changed the plugs, cap & rotor 16,000 miles ago. ...
|
| inner tir rod bushing | 26 Jun 2005 16:56 GMT | 4 |
I have a bad inner tie rod bushing on my 1996 Intrepid 3.3 passenger side. The shops around here want an average of 200.00 to fix this 5.00 bushing. I took a look at this and it does look like a real pain to replace because
|
| Help 2000 Caravan changed brake bulb now ignition will not turn | 25 Jun 2005 22:11 GMT | 2 |
I changed the rear brake light that had shorted out and now the ignition will not turn. Someone suggested the security system locked the car. all the lights and the doors are still active from the remote. Someone else suggested disconnecting the battery for five minutes. It was ...
|
| No start, no crank, no lights, no power? | 22 Jun 2005 18:36 GMT | 2 |
I have a 1991 Dodge Shadow 2.5L and it just died on me when I got to work. I parked the car, turned it off, left for 5 minutes, came back to move the car, and nothing! There was no power to the lights, engine, or anything else. I checked the battery and cables, full
|
| 92 Caravan ECM | 22 Jun 2005 14:54 GMT | 7 |
|
| A Possesed Temperature Gauge. The Story of a Four Cylander '94 Caravan Minivan | 22 Jun 2005 14:22 GMT | 3 |
I noticed that my temprature gadge moves to cold when moving/accelerating and then whenever the van is motionless, the neelde moves from cold to warm. It never moves to hot and can rapidly moves back and forth from the halfway mark to cold. I'm thinking a loose wire somewhere ...
|
| 1998 doge daytona help needed | 22 Jun 2005 12:36 GMT | 1 |
I have had several mechanic shops look at my car . it was running fine until I had some gaskets resealed car came back running like sh.t and now is untrust worthy. it starts and runns miss fires on down shift but when it heats up the idle
|
| serpatine belt keeps coming off | 22 Jun 2005 05:36 GMT | 7 |
I have a 98 dodge grand caravan..we have replaced the serpatine belt 5 times.why does it keep shredding off?
 Signature Posted using the http://www.autoforumz.com interface, at author's request
|
| ? Small Puddles of antifreeze under the the motor on the driveway | 22 Jun 2005 01:36 GMT | 4 |
I own 88 Dodge Charger, automatic trans, 4 cyl. Over the past week I have noticed wet spots in the driveway, today I checked it out and it appears to be antifreeze. It seems to be under the motor area that it is leaking.... I believe that it might be a blown head gasket...but I ...
|
| Neverr mind on the model number - I have it now | 21 Jun 2005 21:13 GMT | 1 |
OK, Grammie got the model# off the tractor. It looks like we need the right front spindle, the flange bearing, and the rubber cap. She was talking about coming into town to pick up the old parts so Bill can order the new parts, and if possible, press out the old flange bearing
|