the car runs great for a minute or two then it will drop into granny gear
and wont shift  then when you shuit it off it will be fine  until you
drivwe it for a minute or two then it will again drop into granny gear
anyone have any idea what is wrong and how i might fix it

HELLO EVERYONE I PURCHASED A 1996 DODGE GRAND CARAVAN WITH A 3.3 LTR V6 THE
VAN RUNS LIKE NEW BUT ITS EATING TO MUCH GAS I HAD THE THING SCANNED FOR
CODES IT CAME UP THAT THE OXYGEN SENSOR WAS BAD WOULD THAT MAKE THE VAN
BURN A LOT OF GAS COULD ANYBODY HELP I AM GOING TO HAVE IT ...

And then there's this.
http://www-odi.nhtsa.dot.gov/cars/problems/complain/results.cfm

Hello Group,
I am putting an engine in my Intrepid 3.3
I am wondering how to line the engine up to the transmission.I am not sure
of the sequence of putting it back together. I have the engine installed and

what is the best wat to remove the serpentine belt tensioner ? The
tensioner (not the pully the spring part)  broke as I started it sun.
nothing seems lock up all pullys turn freely, AC was not on.
99 caravan 3.3

I have a '01 grand caravan and when taking a long trip the condensation from
the air conditioner runs under the carpet on the passenger side and collects
in the carpet.  I have had it to the dealer 2 times the second they said the
cabin air filter was plugged, it didn't help one ...

please please help me my brother passed away and my mother aquired his 1996
dodge intrepid with a 3.5 ltr motor the car ran great for two years and
then two weeks ago it lost reverse and was stuck in second gear me and my
brothers are very mechanicly inclined and we put a trans in ...

Hello Group,
I am putting an engine in my Intrepid 3.3
I am wondering how to line the engine up to the transmission.I am not sure
of the sequence of putting it back together. I have the engine installed and

Hello all, I’m new to the board and I’m having a problem with my ’96 Stratus that I hope you can help me with, Every time I try to start the car I immediately blow the pcm/asd fuse, (fuse #5), the engine will turn over but it will not start. I pulled he wires off the starter and ...

My light comes on during startup to show that the bulb is working but then
it goes out and stays out even if I pull the dip stick or short across the
plug.
I know it's supposed to come on when transmission fluid is low but noting

I have a 1994 dodge shadow ES, and have two problems.  the first is
that the dashboard lights do not work, the dome light works when you
open the door but will not turn on from the dimming switch.  Next my
gas gauge flucuates irratically and will not steady down to show the

 What should i choise, an european or an american car?
thanh.hedgespeth@booomail.com

Can someone please tell me how the heck to get the pair of steel coolant
lines out of my van...? It is the set going from the firewall down to the
bottom of the van.. The replacement one are made of aluminum.. go figure...
I can't even get the old set out!!! HELP ME PLEASE..

I'm working on my 1977 dodge 360-3 engine. At first it was running OK. then
I needed to pull the distributor to replace the oil pressure transmitter. I
put the distributor back (aligned with old marks and now I get some really
back backfiring; flames shooting up from the carburator. ...

While commuting to and from work (60 miles on interstate hwy) it sounds like
I'm driving on a set of  knobby off road tires (the tires are BF Goodrich
radials).  All emissions/exhaust have been replaced and passed inspection
within pass week.