| Thread | Last Post | Replies |
|
| 99 Dodge Neon | 31 Oct 2005 23:24 GMT | 2 |
I have a 99 Dodge Neon which recently started exhibiting some bizarre behavior. Originally I had to replace the radiator due to corrosion. So I got a new aftermarket radiator, new hoses, thermostat, replaced everything, filled her up with 50/50, ran the car until all the
|
| water in the oil | 31 Oct 2005 23:21 GMT | 4 |
i have a 2002 dodge caravan 36,000miles i had the oil changed, antifreeze put in and the car washed at a dealer...59 miles later the car is clunking...i had it towed back to the dealer and they say i have water in the oil that i went through a puddle and will cost thousands to ...
|
| 2000 Dodge Neon- Heater | 31 Oct 2005 15:49 GMT | 2 |
I just had the thermostat replaced but it still not blowing hot air. Apparently they also changed the gasket and they flushed it. Any ideas of what else could be wrong??
|
| 91 dodge dynasty | 31 Oct 2005 06:37 GMT | 1 |
my car will only run for 15 secs.or so any ideas
|
| Replace an automatic transmission myself? | 31 Oct 2005 03:36 GMT | 6 |
My '92 Shadow's 3-speed auto transmission has just self-destructed again. This transmission has been rebuilt twice before. This last time it lasted a hair under 2 years and about 20,000 miles.
|
| switched tires and have a problem | 31 Oct 2005 01:57 GMT | 1 |
i swithed from my stock rims from 17 to 18 inch tires too. had them balanced but get a rough ride about 65 to 70 do i need to have the car alined . the balace is good what should i don
|
| 1997 Plymouth Neon starter problems | 30 Oct 2005 11:36 GMT | 2 |
My friend was trying to change the starter in a 97 Plymouth neon. He was using a Haynes manual and one of the steps was to brace the engine and remove the front engine bolt. Then let the engine slide back to get to the starter. Well, he didn't brace the engine and the engine slid
|
| colt 200 -- water inside... | 30 Oct 2005 00:06 GMT | 4 |
x-posted mitsubishi/dodge/chrysler/plymouth 1989 colt 200 (2000 series) has water (2 or so inches) on the floor. it had leaked water through the tail lights (into the trunk) but these
|
| Mr. Transmission rip-offs | 29 Oct 2005 06:51 GMT | 2 |
Be very aware of using the Mr. Transmission franchise for auto repairs. I learned my leason when I was over $3000 poorer and had to have the dealer fix my vehicle when they got through with it. Andrew
|
| 88 Aries has NO heat | 29 Oct 2005 00:05 GMT | 10 |
1988 Dodge Aries 2.2 AT 4dr Blue with grey interior does not produce heat for defrost or heater. Cooling system has been flushed, Thermostat replaced, Heater Control Valve replaced. I have flushed the heater core (real easy to get to hoses on this car ) and it has good flow. I can
|
| FS 66 New Yorker 440 V8 J Code | 28 Oct 2005 13:55 GMT | 2 |
Nice running driving New Yorker with the 4bbl J Code 440 V8. On E-bay Motors http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=4585707980 Thanks
|
| Headlights wont turn off | 28 Oct 2005 11:12 GMT | 4 |
I have replaced the headlamp switch and relay and the headlights still will not turn off. I took the fuses out thinking I could still drive in the daytime, but even with the fuses out the battery still drains while its sitting (not running). These are the only things I could think ...
|
| QUESTION ABOUT ANTENNA | 27 Oct 2005 03:41 GMT | 10 |
Ok, was wondering if anyone could tell me the real reason for the spirals around the antenna on my truck and the black dots on the top of the windshield
|
| 91 Dodge Caravan ignition switch replacement | 26 Oct 2005 23:16 GMT | 3 |
...the ignition lock on my van has disintegrated. Basically, the sleeve that goes into the barrel came out with the key, and a lot of pins and springs fell out too. It had been loose for a while (and causing some electrical trouble too, I think) but now it's history. I've looked ...
|
| How do you install a heater control valve on a 1990 Plymouth Acclaim 2.5? | 26 Oct 2005 19:09 GMT | 1 |
I am trying to find out how to replace a heater control valve on my car. I am not sure how to know what hose goes where, can someone please help me? If so please provide as much detail as possible I am a "Rookie"
|