I am looking to buy a rebuilt or crated 4.0L SOHC for my 1997 Explorer.
Perfer Ontario but will consider others.  Must be complete.
reply - jabbey@canada.com

I was wondering if anyone has the files that were posted on
http://www.glue.umd.edu/~singletn/exp.html
I took for granted his page would always be there and now he has moved
on and his page is no longer available.

I had my engine oil changed and checked it about a week later and it was
2-3 inches over fill line.  I took it back and had them drain the excess.
I checked it again today and it is about 6-8 inches over and seem a little
thin.  Radiator is still full of fluid.  Where and how can ...

I just bought a '97 Exploder from a dealer and it didn't come with remotes
to unlock the doors.  It has cruise control and power windows and door locks
and such so I suspect it may have it in there somewhere, but where do I
look?  On my '92 it was inside the kickplate on the ...

Looked at their website and found a turbocharger for my Ford 4.0 SOHC Sport
Trac. Anythoughts of comments if this is a good idea? Comments and
viewpoints highly appreciated.
Mike

I have a 94 Explorer with 248K miles and at the end of my rope.
After warm up only, it misses and backfires around and above 4000 rpm.
I have replaced the following (in this order) in an attempt to correct
it and am now broke. I lost the "let's replace this sensor game".

I have a 93 top loaded trans with no thied gear all other gears are fine but
third is an open hole is it possible that I may hve lost a pin holding a
fork or sonething like that?? One day I shifted into third and nothing was
there! I dont think its the gears as there was no warning ...

Well, it was going to happen sooner or later. But I wonder why the
Explorer is not listed.
http://www.msnbc.msn.com/id/9241475/

I do not mean totally internally... I mean with the rear hatch open.  My `94
did it just fine, but without actually measuring, it looked to me like the
newer openings were narrower.  In the `94 the panels rested on the wheel
wells, and I added several 2X4's in the center for ...

I need to replace the factory speaker.  What tool do I use to remove the
door panel, and how do I begin?

my truck is having electrical problems.
i think i have tracked it down to the positive terminal that runs from the
battry.  this terminal has three leads, 2 are 4 guage one runs to the
solinoid and the other to the starter, the 12 guage wire runs from the

We recently put on a new cellnoid (SP?) and alternator and new battery and
now when it starts up it grinds and we are unable to find the cause. Any
suggestions?

I need help with the bolts on a fly wheel.  I need figure out how many
bolts to take off the transmission.  If you could direct me to a wwebsite
with diagrams that are free to view that would be great!

if the Gods will it, tomorrow will be the last  time i drive my
explorer. i'm moving on to a 05 monte carlo. no more waiting to see what
will happen when i hit the key....all jokes aside, my explorer has been
a trouble free vehicle. it has 144000 miles on it, never failed to start

What are some modifications i can make to my 2000 ford explorer xlt 4.0 v6
SOHC to get better mileage?