I have a 1993 ford explorer. One of the manual locking hubs wont shift
out of free position but after putting it on the hoist and turning it
it spun the drive shaft indincating it was in lock position. When
driving it I get a horrible grinding noise that increases with speeds.

I started having trouble with the ol' girl initially with the
speedometer flickering and the cruise control responding to this
flickering and hunting to try and maintain proper speed.  Just a couple
days ago I was pulling my trailer out of a snowbank and had it in 4X4.

Put the MILLENNIUM + on your vehicle or your spouse vehicle and you can
find out where that vehicle is EXACTLY!!!  It is Advanced Internet Based
GPS Vehicle Tracking. You can also find out how fast the vehicle has
been going, and even call your cell phone when it exceeds a specific

I'm driving along and all of a sudden there is a rubbing/grinding sound
coming from the front wheels.  I figure it has something to do with the 4
wheel drive, so I pushed the 4x4 button and it locks in, stopping the
annoying sound. When I pressed the 4x4 button again, the 4 wheel ...

Hello - the back doors of my 98 Explorer XLT will not open from the
inside when the doors are unlocked.  Any thoughts as to how to solve
this problem?  Thanks.

I only a one spark from coil while turning engine over! In order to get
another spark from coil you have to turn key off and turn engine over
again. Thank You for your help with this problem!  1941-9N-Tom

i did a self diagnotics test for the cruise control on a 99 explorer, after
replacing the brake deactivation switch (which is what i got from the test)
it still gives me the same reading   does anyone know where i should look
next.....remembering my test still indicates the BDS is ...

I have a "91 Explorer that I have had since new.    And I have managed
to repair all of the common problems associated with these early
trucks.   Now another issue has arisen.
The female end of the drivers seat belt is failing.   About half of

I just got a 99 Explorer.  The tool for lowing the tire is missing.  (well,
you can't think of everything...)  What does it look like?  Maybe I can make
something else work.

I am looking at a 99 Explorer.  At low speeds there is a vibration and a bit
of a rumbling noise.  It goes away at higher speeds.
The owner says it is due to one brand new (drivers side front) tire with an
aggressive tread.  (the other three tires are worn, but okay)  He says the

I was into Sears this morning having a tire repaired using the road hazard
guarantee.
They are pushing a product called Zoom. It claims to clean, injectors,
valves etc.

I stripped a wheel stud on the rear wheel while changing a flat. I
purchased a new stud and bolt at the auto parts store and will try to
change the stud tomorrow. The truck has rear disc brakes. Is it simply
banging out the old stud and putting the new one in ? Any advice

My light panel says door ajar and all of the doors are shut.  The interior
lights stay on and run my battery down.  Has anyone encountered this?

My sons owns a 1994 Ford Explorer and this past Dec. his car began to
run very bad and it was determined that he had a gasket leak in the
engine and the engine was shot/ gone. He then had a salvage yard put in
a used engine that had 88,000 miles on it. He got the car with the

This is the part number of a 4 liter explorer engine.
Which one?
I have the chance to buy it new.
My explorer is a 1997 SOHC model.