The front brakes on my 93 Explorer are not releasing once I activate
them.  I also believe that the wheel bearings are going out.  Is there
a way to fix the brake calipers without having to replace them and has
anyone else encountered this problem?

A tail light went out on my 96 explorer. When I tried to open the
tailgate, the handle broke.  How can I get the tailgate open to
fix/replace the handle and change the bulb.
Local police don't like me driving around without tail lights.

I have a 96 EB AWD V8 with 242K miles on it.  The headlights are starting to
take on that yellowed appearance.
Has anyone else tried any of the aftermarket OEM replacements, or the
"Diamond cut lenses"?

Hi: I am new to the group and have a problem with my 1992 Explorer.
the other day I needed to use the 4x4 in the snow. I selected 4x4 via
the dash panel..........the light came on............but the vehicle
did NOT operate in 4 wheel. I tried deselecting etc but to no avail.

my engin light stays on and millage is lousy  was going to ream out or
replace catalitic and also o2 sensor but dont know where its at. any
body know where and have you ever replaced it?

Just bought a 98' Explorer and had some questions regarding some noise
I hear under the hood. The truck starts fine, idles fine everything
works great. When I go to drive off after a minute or so from a fresh
start, the engine makes a clicking or rattling sound in rhythm with the

For those of you who have or had a manual Explorer, what kind of like did
you get out of the clutch. Per my other recent posts here, I've just brought
my XLT tot he dealer for a clutch pedal problem. And the dealer is
suggesting that now - 85,000 miles - is a reasonable time to do ...

Per my earlier post (Clutch issue 92), I've decided, as advised, to have the
clutch fluid replaced. A Ford dealer says they can do this and test the
system at the same time. The dealer has a $90/hour rate. That seems a bit
high (northern Westchester, NY) Just wondering what rates ...

OK I know it needed it even though no bad signs or sounds. I changed
the trans fluid and filter.It was due. Also drained the transfer case
and changed the fluid. Used Mercon V as the manual stated. Started off
to work the next day and as I slowed down it jumped out of gear started

Hey all,
I've got one I can't figure out and would definately appreciate some
thoughts and feedback. I've got a 98 5L V8 XLT AWD. The problem is that
when I am in Drive and hit the gas I get a clicking noise, sounds  like

The passenger-side fog lamp on my 2005 Explorer took a rock and cracked.
Other than my friendly neighborhood Ford dealership, can anyone recommend
another source (on-line or otherwise) for a
genuine OEM or aftermarket replacement?  I use them frequently and need

My explorer has 80,000 and recently I have notice a low pitched noise from
the rear of the truck. It varies with speed and it's not very loud. It may
be a wheel bearing or something else. Anyone else had a similar problem? How
do you find if there has been a service notice or ...

Hi guys this is my first message, got some great information off you
guys already, just wondering if some one could help me with this one,
I have an explorer 1998 xlt    the heater seems to always be on even
with the airconditioning on (a/c and Max A/c) even when i put the

No grinding just hard to get into gear with clutch all the way down.
While at a stop, effort is less if you go from 2nd to 1st gear then let
out the clutch. My syncros ? Trans oil and rear diff oil have recently
been changed and there is no difference.

after driving through some high water the next day my explorer began
squeaking around the front end, i havent been able to find any zerk or
grease fittings any body have any ideas? thanks in advance  mark miller