| Thread | Last Post | Replies |
|
| 96 EB heater woes | 26 Mar 2007 21:57 GMT | 7 |
My heater will only come on if the outside temp reads 60 degrees or more on the overhead console, and then it doesn't come on every time. I looked through past posts but didn't find anything like this although the "blend door" problems sound somewhat similar. Is there a
|
| spark plugs | 26 Mar 2007 02:01 GMT | 3 |
What is the correct Motorcraft spark plug for 2000 Limited 5.0 V8? I will probably use Motorcrafts; the originals have given me good service. Is it SP432 (Autozone shows this) or AWSF-32EE (owners manual shows this)? Thanks.
|
| warranty question | 24 Mar 2007 16:28 GMT | 2 |
My 2000 Limited V8 has been a little hard to start a couple of times. Instead of just firing up, it just kinds of putts/misses, then dies again. It has only happened a couple of times. From reading past posts, it sounds like the IAC valve may need cleaning or
|
| 2000 Expl O/D Tranny Problems | 24 Mar 2007 16:17 GMT | 6 |
Anyone, I have a 2000 Explorer XLT 4.0 SOHV with automatic transmission. When the tranny shifts from 1st to 2nd gear it hesitates then shifts into 2nd hard. This has happened a couple of
|
| 1991 ford explorer. rear brakes | 21 Mar 2007 14:42 GMT | 4 |
so we are trying to bleed the rear brake line. and it seems like it dosnt want to hit the floor when we try to do it. might it be because of the RABS? Caus we are currently checking that if we have it. but any suggestions?
|
| not the Radius Arm Bushings afterall... | 21 Mar 2007 07:19 GMT | 4 |
I was getting the textbook "clunck" sound in the frontend of my 94 explorer (still had factory RAB's) --I took it to an alighnment shop -hey said the RAB's weren't too bad but, I had the RAB's replaced anyway- I still have an occasional cluck when I hit the brakes-any ideas.
|
| front end noise 94 explorer 4wd | 21 Mar 2007 06:15 GMT | 2 |
i have a 94 explorer, when parked backing out of parking space when the steering wheel is turned all the way i get one loud clunk sound from the front end, sometimes it sounds like it could be from either side, any suggestions, thanks.
|
| 2001 Explorer Sport Fuel Filter | 20 Mar 2007 06:35 GMT | 1 |
We have a 2001 Explorer Sport 2WD, 4.0L SOHC. I got a new fuel filter from the parts store, but when I went under the truck to change it, the existing filter does not match the one I got from the store. The existing filter has two inputs and one output; the new filter has only
|
| 1998 Ford Explorer LMTD Brake Light Problem | 20 Mar 2007 02:59 GMT | 1 |
I just found out my brake lights are malfunctioning. All three lights wont go on until I push hard on the brakes. The guys who changed my oil think its an electrical short since all three back lights are not working. Could it be the Brake Light Switch or a full blown short? I'd also ...
|
| Bleeding brake lines and replacing brake caliper and piston | 20 Mar 2007 02:42 GMT | 2 |
Anyone have or know of any detailed resources/instructions for bleeding the brake lines and replacing brake calipers and pistons for the front of a 93 Ford Exploder. Any specialty tool recommendations? Thanks in advance,
|
| 1997 Ford Explorer. 4WD and 4WD low lights | 18 Mar 2007 16:14 GMT | 2 |
These lights flash exactly 6 times every 1 to 2 minutes while driving. Is this an indication that a sensor or a relay is going out? Doesn't seem to effect the vehicle when it is in or out of 4WD.
|
| 4wd lights blinking - 4wd not working | 18 Mar 2007 02:41 GMT | 1 |
Just thought I should post my results to his group and maybe save someone a $1000+ repair bill like our local ford dealer in Bismarck, ND (there's only one so you should easily figure out who it is) tried to talk me into.
|
| Front Brake Pad Recomendation | 16 Mar 2007 21:32 GMT | 2 |
I am in need of replacing the front brake pads, again, on my 1994 Explorer. I am looking for a recomendation on what type of pads to install. Standard $25-$30 aftermarket pads do not seem to last and usully result in significatn build of brake dust on the wheels requireing frequent
|
| Ford Explorer 1995 Air Intake Tube. Where to buy? | 16 Mar 2007 13:42 GMT | 1 |
I own a 1995 Ford Explorer XLT and I want to replace the Air Intake Tube by i cant obteint it from the oficial seller in my country. If anybody can help me with a On-Line part reseller that can have this part i will apreciate.
|
| expected cost to replace plugs and wires on 99 v8 mountaineer | 14 Mar 2007 20:22 GMT | 4 |
I've done some searching and see what people expect to pay for the plugs and the wires, but I've seen nothing on the expected labor charges to get this take care of. I took my 99 mountaineer with the 5.0 v8 to get the plugs/wires changed out since it started running pretty rough a ...
|