Hi this is my first post.
I have a 1997 Ford Explorer.4wd.
It has been running really rough.
4 liter 6 Cylinder.4wd.

My 99 XLT is due for a muffler and one quote I was trying to get a
question arose if my truck has California emissions. How can I tell? I
did a few searches for the topic and it seems most of the trucks have
it, but I want to be sure. Thanks.

I've had front wheel bearing seals replaced once under warranty at 36K.  The
problem started again at 49K and the Ford dealer said replacement would cost
approx $400.  So I live with the squeak.  Has anyone else had this problem
and has anyone found a solution to this problem.  ...

My 99 Explorer wont start, it was working fine yesterday, but i go to start
it this morning, everything powered up, but when i turned key, everything
just went dead! I have a new battery i just bought a year ago. Anybody have
any ideas?

Reading this newsgroup as well as an Explorer forum makes it seem that the
SOHC V6 has real problems with cam chain tensioners and noise that are
expensive to repair. I am thinking of a newer Explorer or a Toyota 4Runner
(2004-2007). But the cam chain issue has me scared. Am I ...

This is going to be kind of hard to describe so bear with me. I'll try
to post pics later.
I recently renovated my kitchen and I started to install the crown
molding on top of the cabinets(they are not going to the ceiling). One

Ok im pretty mechanicly enclined. However im stumped.Iv noticed since
it has gotton colder
it takes my explorer a few more cranks to start than normal. A few
days ago i started the suv

I am considering buying a 2005 Explorer. How can I tell if it is a flex fuel
vehicle? I see no badges on the car identifying it as such.

The saga continues....
Recently rebuilt the upper engine new gaskets and had valves ground
replaced valve stem seals, heads ground, injectors cleaned and
replaced 2 lifters.

I am losing gas milage on my 2004 Ford explorer LTD. I put in new  plugs
and nothing has changed. Help!!
--
Message posted using http://www.talkaboutautos.com/group/rec.autos.makers.ford.explorer/

Our 2003 Mountaineer sits all day outside my wife's work. Often she can't
get into the vehicle after a day sitting outside in the freezing weather.
She notes that fellow employees seem to not have this problem. I sprayed the
locks with WD 40 but it doesn't help. Any other tricks ...

My 1997 Explorer was hit and run on the drivers door, it is a 4 door
can anyone tell me what year doors will fit? For the record it is
power window and lock, no keyless entry.
By the way the incident was witnessed and the Hit and Run a'hole was

1995 Explorer with failure code 214
I cannot see if the sensor can be replaced seperately or whether the whole
drive unit has to be replaced. Does anyone know if the sensor can be
replaced seperately? If not can the drive unit be replaced without pulling

Just got done changing the water pump in my '93 Explorer Sport.  One of the
bolt heads (of the 12) broke off, leaving the rest of the bolt sticking out
of the engine block.  The one that broke is located in the center of the
bottom side.  We used a good bit of sealant on both ...

95 EB Explorer.  Whenever I hit the brakes, even lightly on dry
pavement, I hear the antilock brake buzzing sound.  The sound is the
same one heard when the truck is activating it's antilocks on icey
surfaces (i.e. when actually needed)