| Thread | Last Post | Replies |
|
| Where can I squirk some lub to cure squeaks? | 30 Dec 2008 23:53 GMT | 2 |
2002 ZX3 starting to squeak when I start, stop, or turn. It's like a squeaky shoe. Since they don't need lub during oil changes, where can I spray some oil to stop the squeaking?
|
| 2002 Focus Voltage problem | 13 Dec 2008 11:49 GMT | 2 |
2002 Focus, battery light intermittently coming on. I've checked the voltage at the battery while the light is on at it is 14.5V. Light usually goes out so I just lived with it. This morning the headlights, blower motor all dimmed very low for about 3 seconds then light up normal ...
|
| Idle speed vs engine speed | 09 Dec 2008 15:51 GMT | 3 |
Little dissatisfied here. Been driving manual tranny cars in the past. When I let off the accelerator pedal, the engine always immediately dropped down to the idle speed normally seen at rest. Doesn't matter if the car is in the driveway, or cruising on the highway and push in ...
|
| ford focus unexpected acceleration | 04 Dec 2008 03:49 GMT | 10 |
I had a frightening experiance tonight. My 2000 Wagon (US) would not stop. When I lifted my foot off the accelerator the car just kept on going at the same speed. When I slowed it down using my breaks, the engine started accelerating higher and higher. I had to shift it into ...
|
| Racing engine, Excessive tire wear, Stupid Factory alignments. 2.0, 2005 ZX3 | 02 Dec 2008 13:52 GMT | 1 |
The below was my response to a post from 2007 asking about a racing engine while driving down the road. I would like to know what others experiences are and their input to this post is appreciated. If you care to respond via email use midecaseya2@yahoo.com
|
| Alignment question? | 02 Dec 2008 13:38 GMT | 17 |
On the camber for the rear wheels, the + .03 to - 2.3. So if you had it aligned and the camber measuremet came it at + .4, would you expect the tech to set it to the specification's midpoint? Firestone told me if it's in spec, they are taught not to adjust it. They also said the ...
|