| Thread | Last Post | Replies |
|
| Auto Trans Reset - '03 V-6 | 17 Aug 2003 06:44 GMT | 6 |
Greetings!! Our new little '03 'vert (V-6 Premium) seems to be having some growing pains in the auto trans area. At slow speeds (around the neighborhood friendly 25-30 MPH) it acts like it's searching for the right gear and then as you
|
| Air Conditioning overhaul | 17 Aug 2003 02:43 GMT | 1 |
I just pulled my '85 Mustang GT out of mothballs after 6 years of sitting (was always driving company car). I now remember why I've held on to it-I'm falling in love all over again. Trouble is, of course the air conditioning is gone...I don't think they make R-12 anymore, are there ...
|
| MONEY | 16 Aug 2003 23:38 GMT | 3 |
---------------------------------------------------------------------------- ---- TURN SIX DOLLARS INTO $6000 EASY AND HONESTLY!!! READING THIS MESSAGE WILL CHANGE YOUR LIFE FOREVER
|
| Car Show -- Aug 17, 2003 (Sunday) -- Coopersburg PA | 16 Aug 2003 21:31 GMT | 3 |
The First Pennsylvania Mustang Club Presents The 27th Annual Coopersburg Collector Car Show & Flee Market Sunday, August 17, 2003 - 10am to 4pm
|
| Can't "Speed Shift" my T5..... | 16 Aug 2003 21:03 GMT | 2 |
..... SOB SUCKS! :>( When I DO try to "Speed Shift" from 1-2, the shifter feels like it's jamming up and HARD to engage 2nd gear. Under normal and "spirited" driving conditions, the OEM shifter shifts OK.
|
| Engine cutting off for unknown reasons? | 16 Aug 2003 19:53 GMT | 6 |
I recently purchased a 1986 Mustang GT with a 1993 5.0 HO engine swap. I have had on a few occasions had the engine shut off during high way crusing and at a few stop lights, as well as it sits in my driveway while idling.
|
| ride height question | 16 Aug 2003 19:39 GMT | 1 |
Hi... I was wondering if there was anyone who could figure out an odd problem that I'm having. I've just recently redone my suspension and 4 speed swap :)
|
| Radiator Pressure Cap for 83 Mustang | 16 Aug 2003 17:22 GMT | 2 |
Recently an independent garage replaced the radiator cap on my 83 Mustang (3.8 liter engine, automatic) with a new pressure cap. Since that time, my cooling system has developed a couple of leaks. The pressure cap he installed says it is 16 lbs. Is that correct for this
|
| adding r-134a | 16 Aug 2003 17:12 GMT | 5 |
My AC doesn't seem as cold as it used to be in my 96. Can I just buy a recharge kit at the local Wal-Mart? I guess I am not sure how much should be put in. I definitely don't want to overcharge it and cause more problems. Any insight would be appreciated.
|
| OT: Cleaning... (not sure if it is off topic though) | 16 Aug 2003 16:45 GMT | 2 |
Anywho, I have been doing some cleaning of my car and I have been using a combo of things. Spray Nine, leather cleaner, yada yada. the problem is that all the dirt isn't coming off the gosh darn seats. My dad even brought me some industrial cleaner from work to clean them with and ...
|
| Power window motor - nylon bushings? | 16 Aug 2003 16:14 GMT | 1 |
My passenger-side window goes up and down very slowly. It seems to be getting slower all the time. I've seen these "repair kits" on eBay that replace the nylon bushings on the motor pins; they say 90% of "bad" window motors just need new bushings. I am skeptical that the window ...
|
| '97 GT more power needed! | 16 Aug 2003 16:13 GMT | 1 |
i'm looking for ways to increase the horsepower of my stock '97 GT without spending thousands of dollars. what is the best way to go about this? where do i start? i'm trying to keep the cost to a thousand or two, and nothing too complicated. i am fairly mechanically adept, but i ...
|
| Side Scoop Removal - 2001 Stang | 16 Aug 2003 05:59 GMT | 3 |
I need help removing my side scoops on my 2001 mustang. I need to paint them, but do not want to damage the car or the scoops in the removal process. Does anyone have directions on the way to do this? Please help!
|
| 94 Mustang 4cyl idle | 16 Aug 2003 01:13 GMT | 1 |
My sons car idles at about 800rpm just a bit to low. It use to idle at about 900-950rpm. The engine has 60,000 miles. It's a 2 plug per cylinder 4 cylinder.If I unplug a switch next to the throttle body it will drop the rpms and jump back up when plugged in again, but not high ...
|
| 87-93 Hood for Sale you Name the Price | 16 Aug 2003 00:39 GMT | 1 |
Hood for sale, in good condition no dents or rust. Underside insulation is well intact but has a few missing places, nothing of concern. Hood is located in the KC area. You may pick up or I can arange for shipping. All inquieries to rhs_boy@Hotmail.com (will send
|