I haven't been on in a few days. Sunday my cobra got run over by a truck.
I'm still paying my respects. I need a couple of good site to find a new
one. I test drove a 2003 gt today, I can't do it it's gotta be another
cobra. I live near philadelphia if anyone knows a good one please ...

My son's stock 289 is getting a bit tired in his 67..He wants to get a
Ford Racing 302 (M-6007-XB3) and put in it..Has anyone done this? What
else needs to be changed..he has a "strongly" rebuilt C-4 and a 9"
rear end..will this bolt up to his current bell housing?

I would like to change out the stock headers and exhaust system on my
convertable 2003 GT 4.6 Mustang.  Problem is that it's a convertible
and I do not wish to increase the noise level.  Is there a way to add
headers and higher performance exhaust and have really quiet mufflers?

Well the ugly Check Engine Light came on again. It came on for about a week a
year ago, got it checked and it was the PO420 code.. "Catalyst System
Efficiency Below Threshold (Bank 1)." After a few days it shut off, so I didnt
think much of it. Now it came back on a few weeks ago, ...

I have a 1966 Mustang with a 289. I have a couple of questions.
1) Im going to be using a modern Edelbrock cam, carb, and intake and
leave the rest stock. Is there anything i should look out for before
putting in this combination? Ive heard some things about the aluminum

Anyone else catch the episode yesterday (Sunday) of Pimp My Ride where they
transformed a rather worn 89 convertible into a pimpmobile ????
They did a super nice body kit (unknown brand) and replaced the Saleen wing
with another aftermarket spoiler which IMO looked better than the ...

i have a flowmaster exhaust with the pipes cut off at the axel. How can i
make my 93 gt louder?
i want it to scream

Brand new to Mustangs . . . before I start looking very seriously for a
2003+ model. What's the general consensus (is that possible on usernet
<g>). Currently drive 2 cars a Ford Ranger (used for daily schleps
around town and to work) and an older Porsche 911 (used for fun trips

Well need some more advice from all you knowledgeable fellow Stang lovers.
My intake gasket went on my 1985 Mustang GT.  I decided since we are going
to replace the gasket, might as well replace the intake also.  So I picked
up an Edelbrock Perfomer Manifold (PN#2121) which is non ...

At Duke University, there were four sophomores taking Chemistry and
all of them had an A so far.  These four friends were so confident
that the weekend before finals, they decided to visit some friends and
have a big party.  They had a great time, but after all the hearty

Car Craft continues to fuel the debate!  Was the 68 Mustang W Code real, or
was it just a pre-production news leak?  On page 26 of their August issue,
"Top 10 List - Best Years for the Ford Mustang", Car Craft listed the 68
Mustang as #7 out of 10.  In the write up of the 68 they ...

Of course my 289 is built, with a hotter cam.
So it puked rusted radiator fluid all over my engine compartment last
weekend.  The radiator was rodded out a few months back.  SO I am hell bent
on doing the right thing and getting a new and better radiator.  3 or 4

Hey all,
I've got an 02 GT with Bullitt wheels (stock) that a tire shop managed to
take a chip out of .  I went to Ford and they have no idea what color paint
is used. They did offer to sell me a new wheel though...