Date: Sun, 17 Nov 2002 06:19:11 -0800 (PST)
From: Alex Edwards <alex_too_true@yahoo.com>
To: maddox@xmission.com
Subject: Post this, I dare you.

Ten days after I picked TFrog up, after detailing the interior and putting
two coats of Mother's on the outside, I'm sopping up green liquid that's
pooling in the rear passenger side.
Somehow, I don't think that's right...

My son is getting ready to paint the '80 2-door but can't decide what to do
with it. Do any of you have, or know of pencil drawings of the Fox 2 door
that he can use to get a visual idea of colours and stripes?
Thanks

I had to disagree with him sometimes. And sometimes he was full of sh.t.
Like when he told me you can lock your '65-'66 without using the key. LOL

I recently purchased a 1967 coupe in great condition (to accompany my 2002
convertible).
I am not sure if this is the correct terminology, but many people have told
me to have something installed between the back seat and gas tank to protect

Anyone know what the initial timing is for a stock 94 GT?....cc

Hey you!... still out there?
Kate

This seems to be the opinion of most
people I run into.  Burnouts are not seen
as a demonstration of power but of
stupidity.  The best idea being to plant the

Anyone know the initial timing of a '65 200 6cyl. ?

I have this ongoing argument with a friend who is against downshifting
on downhills (using the engine to break). Claims it's bad for the
engine.
Thanks

I have read on someone's web site that you only get boost from a KB
supercharger at WOT.  This contradicts what I have read previously
about being able to melt tires at 1/2 throttle, etc.  Here's the page
I'm talking about:

95 GT Convertible with AODE
OK here the deal:  My GT w\ AODE has less than 60K miles, been pretty
much maintainted very well and have slowly been adding MODS to it.
Unfortunately the AODE is not a very responsive tranny, so I end up

Check this out!
http://www.allfordmustangs.com/artman/publish/article_419.shtml
Patrick
'93 Cobra

I can't seem to find any reference to WHERE the gear is located, other than
"on the drivers side of the transmission" (haynes manual is no help, and
googling for it just gives me tons of links to discussions about speedo gear
swaps, not how to do them).  A guy at work who's owned a ...

I just broke down my motor, to get rid of a bad lifter, and I have to put
the heads back on (of coarse cleaned heads, and new head gaskets) what is is
the torque I need to achive for full Windsor Dart heads, ARP studs on a 302
cobra block? Is there a pattern for tighting?  Also I ...