It's time to look at a rebuild. My 289 4v has never been rebuilt, so
unleaded gas has been working it's black magic.
I have two options for this 65 Fastback.... a rebuilt 289, or a
rebuilt 351W.

Has any one use springs form Eibac, DROPZONE, Sprint , Maxspeed  or
FALKEN ? What do you think of them? Anyone else with a comment or
recommendation is welcome to post it. I'm looking for a nice drop of
1.25 to 1.5 inch both front and rear.

I was wondering what would be a good place to order wheels for my
mustang? I have a ´65 coupe. Also not sure if they ship to Finland since
neither has replied to my e-mails. This doesn´t give a very good impression.
I have found 2 sites which would look to be ok. Any experience ...

 A young redhead goes into the doctor's office and says that her body
hurts whenever she touches it.
"Very rare but not impossible," says the doctor. "Show me."
She takes her finger and pushes her elbow and screams in agony.

I own a 1966 mustang that needs somewhat of an overhaul; I am looking
for recommendations for a shop that can perform interior restoration,
exterior painting, as well as fix my brakes.  Does anyone know of any
reputable shops in the South Jersey/Philadelphia area?

Does anybody know how to get hold of the people at STANGERSITE.COM?
I've been trying to reach them using the address on their web site:
rebuilding@stangerssite.com
and had absolutely no response.  

MY SPEEDOMETER IS WACK AND SO IS  MY GAS GAUGE? WHATS UP WITH THE 87-93
MUSTANGS WITH THE GAS GAUGE SPEEDOMETER RPM AND EVEN THE MILEAGE GOING
OUT? CAN SOMEONE OFFER SOME ADVICE ON HOW TO TROUBLESHOOT THESE PAIN IN
THE NECK AREAS. ESPECIALLY THE GAS. I LITERALLY HAVE TO RUN OUT OF ...

i have an 87 t-bird lx.
have replaced most of the sensors and relays, new belts and hoses, cleaned
the throttle body. disconnected the battery to allow computer to reset and
set idle to factory spec with computer disconnected.

Cruise control not working and if you pull the cable back and forth you can
hear something clunk at the far end.
Any ideas

I'm in desperate need to crawl under a 67-68 and just do a few
measurements (ebrake brackets and what not) before I weld them in. Also
want to look at how it's painted and where the paint starts and stops..
I'm located about 1 hour west of Toronto.. Any help is greatly

Ford is advertising their Presidents Sale. The 05 Mustang is mentioned. I'm
going to stop by and see if it's BS.
Al in Tucson

I have replaced the master cylinder twice in a year and a half on this
car.  Now, when at a stop, there is good braking, then it falls away
under my foot an inch or more.
Does this have to be the master cylinder, or can it be something else?

anybody know where a good place to order BBK 1615 equal length chrome
shorty headers?
cheapest i have found is $274 shipped.

We've all got a few online sites that we know about for new or used
parts, and other information.  I've learned about a few already here.
What sites do you think are the best?
'98 Mustang - 3.8 - 5 Speed

I know the '94 thru '98 Mustangs are similar, but just how similar?
Will most used parts work for each year?
Interior parts?
Engine parts?