| Thread | Last Post | Replies |
|
| Coolant Leakage. On & Off | 11 Aug 2005 04:52 GMT | 3 |
Well Kate you were as good as right. The leak did occur at a frost (freeze) plug only that the plug had been replaced with a block heater (I think the factory does that for the Canadian market) . Element was corroded but leaking occurred around the "O" ring. Whole assembly must have ...
|
| 1990 mustang rack and pinion question | 11 Aug 2005 00:03 GMT | 2 |
I have a power steerring fluid leak coming from the rack and pinion. Can just the seals or somethign be replaced in the rack? Is this hard to do? The dealer wants 217 bucks for the rack. Autozone wants 90 but I am
|
| Pity Chrysler (was, The Dukes of Hazzard) | 10 Aug 2005 22:14 GMT | 85 |
They refuse to allow their cars to be used in the "Dukes of Hazzard" movie because of the Confederate flag and that movie will probably do massive box office. But, they give the producers of "The Island" an typical, politically-correct Hollywood movie a huge number of their
|
| My car made the Graphic Express catalog | 10 Aug 2005 17:59 GMT | 1 |
http://www.graphic-express.com/z-scott_williams.htm
 Signature Scott W. '66 HCS Mustang 289
|
| '94 rear break line | 10 Aug 2005 15:14 GMT | 1 |
my rear break line rusted through and im being told that the fittings on either end are two different sizes and that i either have to find another mustang '94-'96, because those are the only one's made that way, have a line specially made, or hope to find an adaptor that will work. ...
|
| Mustang A/C compressor cuts out | 10 Aug 2005 15:07 GMT | 2 |
I have a 92 Mustang GT with the A/C converted to R134. All is fine except after about 15 to 20 minutes of operation the compressor quits operating. It starts working again after a while. When the compressor quits working, the pressure switch on the
|
| 351w old to new swap | 10 Aug 2005 01:19 GMT | 13 |
Ive got a 69 coupe with a 351W, big bell C4 auto. Eventually I want to either get a DSS 408w shortblock or build my own Windsor stroker to swap out. I will be using all new parts on the new block so Im just worried about things like tranny bolt pattern, flywheel, and whatever
|
| SN65: Bob Julian's Retro-Cobra | 10 Aug 2005 01:04 GMT | 9 |
He has homologated all the stuff and pix from Horsepowered, plus a LOT more into a website: http://sn65.com/
|
| Hey Kidd... | 09 Aug 2005 02:13 GMT | 8 |
So do you have an old VW or what? Joe Calypso Green '93 5.0 LX AOD hatch with a few goodies Black '03 Dakota 5.9 R/T CC
|
| Ontario's OPP finally admits that.... | 08 Aug 2005 23:56 GMT | 4 |
...the biggest cause of crashes on the highway is TAILGATING and NOT speeding. The OPP are the Ontario Provincial Police and it's their job to patrol the highways. It's pretty
|
| turbonator | 08 Aug 2005 23:38 GMT | 109 |
has anyone tried installing the turbonator on there mustang and if so what were the results? http://www.turbonator.com/index.html?id=adWordsMustang I have a 02 GT and was wondering if this add on might be worth while.
|
| Hubcaps for 2005??? | 08 Aug 2005 21:06 GMT | 3 |
Just picked up my 2005 convertible yesterday, the one thing I dont like about the appearance are the hubcaps. I went to hubcaps.com and found some I like on the mustang page, but my question is do all the Mustang hubcaps they sell fit on all Mustangs incl. 2005? The site isnt
|
| Good site for after market stuff for 2005? | 08 Aug 2005 21:05 GMT | 1 |
What are some good sites for the after market products for the 2005? Thanks
|
| carfax | 08 Aug 2005 20:05 GMT | 1 |
My daughter is looking at a '93 Cavalier. I would appreciate it if someone with a carfax account could look it up for me. Email me at stignasty@gmail.com if you'd like to help. Thanks
|
| Coolant Leak. On & Off | 08 Aug 2005 15:58 GMT | 3 |
This AM while at the drag strip I was pulled off the line as the car was leaking coolant. (steady flow from the back of the engine area.) By the time I got back into the pit area the leak stopped and could not be located. Drove back into town (about 5 miles) and the leak started ...
|