Midwest Auto Gear is now selling the Plenum Covers for the 2005-06
Mustang.
It is available for both the V-6 and V-8.
There is a no reserve Auction on Ebay.

Any ideas for unsticking a stuck distributor? Checking the timing for the
first time since owning the car made me realize that the dist is stuck and
will not rotate. I loosened the hold down bolt and bracket and they move
around just fine but the distributor refuses to budge. ...

A recent 5.0 Magazine article had a shootout of 4 intake manifolds,
which confused me somewhat.  I was under the impression that the intake
runner length and design give the intake a specific power band, which
the rest of the engine components should match.  The Holley and Trick

 I'm having a problem with my 93 5.0..  it starts and runs fine, but
around 3/4 throttle or more it noses over and dies.. backfires until
you get off the gas.  I just pulled the codes today.. I'm getting codes
18, 41, 91.  I also ran the cylinder balance test and everything was

I have a 351C from a Fairlane 500 which I am tempted into slotting it into
my 68 Coupe. My concerns are as follows:
1. I noticed that the small heater hose spout on the engine block is broken
due to rust. (It seems like an integral part off the block). To explain, the

Anybody ever notice that there are "three" hosts on "Two Guys Garage" on
Speed Channel????

So I have a 69 351 Windsor block that I have put a 393 stroker kit in.
I have it all built and it starts up and sounds smooth, however there
is a slight rapping noise coming from the bottom. I have pulled the pan
and checked the clearances of the counterweight to piston skirt.

Courtesy of Ontario-Canadas DIMWIT Liberal government.
1.  They threaten to withold car or other vehicle licenses from teens
who fail to graduate
from high school.  So, one very important avenue to employment

Catalytic converters: source of pollution?
Massachusetts scientists say toxic metals from automotive catalytic
converters have been detected for the first time in U.S. urban air.
The research was conducted by Swedish scientists working in

http://www.detnews.com/apps/pbcs.dll/article?AID=/20051217/AUTO01/512170310/1148
Also see http://www.fordmanifoldsettlement.com/

Hullo,  I'm contemplating of  slotting a 351 cleveland from a Fairlane 500
into my 68 coupe but wondering:
1. Would it fit with the original cast iron headers.
2. Could I use the original 289 engine mounting brackets. (They however look

Motorcycles emit 'disproportionately high' amounts of air pollutants
Motorcycles collectively emit 16 times more hydrocarbons, three times
more carbon monoxide and a "disproportionately high" amount of
other air pollutants compared to passenger cars, according to a Swiss

I have always thought the perfect vehicle combination was a Jeep (Lifted
with big tires) and a Mustang 'vert. Well I recently bought my 99 'vert and
I all ready had a 91 Cherokee with a 3.5" lift and 31" tires. Came out this
morning, and what's not there? My freaking Cherokee! So ...

Does anyone know the correct factory specs for the 351W-2V cam?  Lift,
duration, lobe separation, etc.  Thanks.

I was wondering if anyone has some expertise in all-season or snow tires for
Mustang GT's.  I have a 2003 GT and we had 4 inches of snow the other day.
My car was almost un-driveable.  I still have the original factory Goodyear
Eagles on it, and was wondering if it is worth my ...