Is the color dot mark on the tire sidewall have any significance? I thought
that the dot was to be lined up with the valve stem so as to better match
the rim weight imbalance with the weight imbalance of the tire itself.
Asking as I just had new tires installed and the color dot and ...

I have a 93 ford Mustang and the tach isn't working, the check engine light
is on. It's the 2.3 with the eight plugs. Any one have any suggestions on
what to look at ? I mean, what usually causes this on this car ?
I might add that the head gasket was replaced. When I got the car ...

I have an '04GT standard shift, and sometimes it cannot find reverse. I have
to press/depress the clutch a couple of times until the shifter can find it.
Is this normal with this tranny, or do I have a problem.
TIA...Gumby

is there any real benefits to adding a hypertech power module to speed
density 86 lx 5-speed or any problems with this upgrade input would be
very appreciated

1989 5.0 LX hatchback, AOD, air, power steering/power brakes,
non-California Mustang
------------------------------------------------------------------------
Ok, so I've lurked here off and on for several years, even posted a time

Hey Guys & Gals,
I was just curious if anyone can tell me the best way to take out the
Washer tank and the pump.. I have a 90 LX 2.4L and the chilton manual
is a piece of crap I'm finding out. The guy who I bought the car off of

So I just installed a new wiper motor but I hooked something up wrong. In
the start position the wipers have to be up all the way and then they come
down to the hood. When turned off they go back to the full up position.
Any ideas?

Any reason I can't mill away the lip on the 289 crank and use it in  a
later block. Other than the lip, the crank appears to be dimensionally
correct.
Thanks.

Is there a place that we can do searches on specialty Stangs (ie Saleen,
Roush, etc..) and see the going rate? For example what a 2005 Roush stage 1
with 3k one owner miles on it. Any help appreciated thanks.
Nick

On Wed, May 10 2006 10:09 pm, Jim Warman wrote:

I just bought one and am not sure about installation. I understand it's just 2 wires, but in the specs, it talks about a 1.65L ballast resistor. WTF!?!?! This is going on a '69 with a 351W. Ford didn't use ballast resistors did they? I thought they used the pink resistor wire. ...

My Capri was relieved of the deck lid louvers a few months ago by a vicious
windstorm. I have all the pieces - what is the best adhesive to use? The
original looks like super heavy duty, black double sided tape.

"Blue Mesteno" <69ta_mustang@comcast.net> wrote

Group URL: http://groups.myspace.com/wildheartsmustangcrew
Turning heads and corners! A brand new group for grrrls who own a too
hot to trot Mustang! But this is only for the ladies who rock the new
retro styled 2005-2006 models - the modern revival of the '67-'69

I have a stock 88 Mustang GT with AOD trans. Can I put an F303 cam in
the engine with no other modifications?