I have always wanted a decent mustang...   ever since I was about 8..
wanted one so bad I could taste it really...   I used to be fairly
active on these forums..   but have not really been back in quite some
time...

well, nobuddy could agree on what kind of wax to use, how about this:
got the factory authorized bra for my '06.....what a bear to
install!!!!!  took an hour to stretch it and fit all those "shims" in
around the lights & grill.

1. Distracted drivers talking on cell phones (known as Motor Mouths)
2. Slow drivers in the fast lane (Turtle Racers)
-- I like to call them rolling road blocks.
3. Pushy drivers who tailgate (Piggybackers)

I have an '01 Ford Mustang, 91k miles, 3.8 V6.  Recently, it had an
engine misfire and I had that fixed.  Then I had a faulty EGR valve and
had that replaced.  Fuel system clean, EGR sensor also taken care of.
Tune-up in September, 05, done by a very trustworthy professional.  THE

Our [performance] "future is so bright, gotta wear shades"?
Hmmm... maybe EVs won't be so bad after all.
This is a good read... take a look..
---

I have a 02 mustang 3.8 and am wondering where the fog light harness is
located under the hood. It is attached to the switch console inside but I
have yet to find where it goes under the hood . Any help would be
appreciated!  Thanks!!!  Guy

Poking around under the hood of my kid's 79, I noticed what looks like
a loose hose. One of the lines between the poweer steering pump and the
[steering gizmo under the engine] swtiches to a hard line, which moves
freely as if it isn't fully tightened. Unfortunately, I can't figure

<deadcarnahans@charter.net> wrote in message
news:1146672740.465388.79120@e56g2000cwe.googlegroups.com...

I had the driver's side motor mount repaired on my daughter's '66
mustang.  Within 30 days the motor mount broke (the original passenger
side mount didn't break).  When mount broke, the engine torqued, ruined
the brand new radiator, and the new paint job on the hood.

I am trying to take my cluster out of a 1981 Mustang but cannot get the
speedo cable off it. There is a white plastic piece on the back that I dont
want to break. Cna anyone tell me what to do?
Thanks

Hey All -
Do any of you go to the Saturday night car meet at Home Depot in Cedar
Park?
I'm (hopefully) about a month away from completing the 68 coupe with the

2007 FORD SHELBY GT500 OFFICIALY RATED AT 500 HORSEPOWER
Ford Shelby GT500 officially rated at 500 horsepower, 25 horsepower
higher than preliminary estimates.  The Shelby GT500 will go on sale
this summer with more horsepower than any previous factory-built

Is anyone else seeing this? I don't feel like dropping money to retint
if it's going to keep doing this.

Build your Custom Plenum Cover
Thousands of color combinations
Looks like they are still working on the page
www.midwestautogear.com/custom.php

I am looking for a set of Rocker Panel Covers for a 1970 Mach 1.
I have looked everywhere that I know of and have not found any reproduction
sets.
I have found a few here and there on ebay, but not a complete set.