http://www.wesh.com/painatthepump/9141621/detail.html

I need to remove the speedo needle on my '66 to install a white face
applique. Any know how to do it properly?

My 400cid 351 Windsor stroker is only running 9.2:1CR but it's pinging like
crazy on the 85 octane here in Colorado. I've checked the gaps on my plugs
and the points, retarded my timing so far back it's probably -4 initial
(timing light doesn't go below 0). It STILL pings!!!! ...

Hello, I'm trying to replace the sound system in my 1995 Mustang. Can
anyone give me any tips/links/advice? I need all the tips I can get,
ranging from head unit removal, to wiring diagrams, etc. etc. etc.
THANKS IN ADVANCE!!!

i've got a new pump ,good lines and cylinders,13 to 14volts at the
plug for the pump,and when i try the switch all i still get is the
click from the resistors.any suggestions would be appreciated cause i
have no ideas left

I have a 2001 GT Convt. which is stock and was wondering if anyone had any
power tune up tips that cost less than $1,000 and does not compromise
engine/transmission life? Thanks in advance!

Amid the current panic about gas prices many people are embracing ethanol.
But that's not such a good idea...
http://www.businessweek.com/print/autos/content/apr2006/bw20060427_
493909.htm

My '95 mustang has a jerky acceleration when it warms up and car shakes
when I'm sitting at red light. When I start the car it runs ok but it gets
worse when the car warms up. I replaced spark plugs, put in injector
cleaner into gas but that didn't help. Does anybody have any ideas?

Hey Fellow Mustangers -
At approx 129,900 miles my "check engine" light came on and stayed on.
Is this programmed into the computer to happen for all 96 Mustangs?
Or... is there the possibility of something serious wrong with my engine?

On two of my fox body mustangs I have unfortunatley encountered
(somehow at the same time...;sigh;) the driver's side interior door
handle failure. I have had the actuator / and/or rod inside the
door-mechanism come apart; although in this case the interior handles

Can someone please tell me which port is the low-side on a 1996
mustang?  Assume i'm a complete idiot and have no idea how A/C works.
(Which is half-true -- i'll let you decide which half)  Is it the port
closest to the firewall or the radiator?

Read my Story at:
www.skywolf.com
or contact:
888carrillo@cox.net