Bought a center console on eBay from '71 Mach 1 that has
a non-working clock.  Mustang Monthly had an article dated
January 2003 page 26 describing how to repair this clock.
Is there a way  to retrieve past articles online?

I hope that it's okay to post this here.
My father has a passenger side door and front fender for the 64 1/2 -
66 Stang.  They are in good shape.  He's in Palm Beach County, Florida.
561 842-3378

I think the 93  5.0 has some carbon built up as the compression test numbers
are higher
Is there a way to clean it out without taking the heads off?

I need a head that is intergrated intake manifold and a bolt on exhaust manifold.
Thanks
email mustangbutch@(spam) cox.net
remove (spam)

HI, I bought some 255/60 rear tires for my 67 coupe, after recieving
completley incorrect advice about tire fitment, and now they stick
outside of the fender where if I lowered the car off the lift the lip
of the fender would cut into the top of the tire. Could I raise the

About a month ago my 67 mustang GT just stopped turning over.
The battery is good.
It was in hurricane season so it was humid but i didn't think it could
cause any damage.

I recently traded in my 2005 GT for a 2007 GT Convertible.
The car at light acceleration (not hard throttle) exhibits a shake like "a
dog wagging it's tail".  The dealer has confirmed the shake and are working
on correcting.

What should the water level be in a cold radiator?
My 351C 4V in a '71 Grande  radiator's water level
is about six inches below the filler when the engine is cold.
The car has never overheated and typically runs

. The new Ford Shelby GT is the third model in the modern Shelby
Mustang portfolio, joining the 500-horsepower Ford Shelby GT500 and
Hertz rental special, Shelby GT-H.
. The 2007 Ford Shelby GT will be priced a starting MSRP of $36,970.

Hello all.  I have finished putting the 5.0 in my coupe.  Everything is
hooked up, I have plenty of fuel pressure.  Spark is somewhat intermittent.
I thought my distributor was 180 out,  but that didn't help.  Suggestions?
Gary in GA

I'm asking all of you who could help me ...I own a 1972 MUSTANG Coupe''
SPRINT '' Canadian limited editon and I couldn't find anything on it?
If someone could send me some informations about this particular car I will
really appreciate!

I need some help removing this little bugger. It's the one on the driver
side header. Can't seem to get half a dozen wrenches to get a good hold on
it.
Is there a special tool or procedure?

http://www.consumeraffairs.com/news04/2005/acceleration.html
August 22, 2005
The victims of sudden acceleration all tell a similar tale. "I got into
my car and turned on the ignition. I put the car in reverse. The car

Is it possible to repair the rust/corrosion problem around the rear window
of this 66 Mustang?
http://photos.imageevent.com/daxop/posts/rust.jpg
I am looking to purchase this car but if this problem can not be repaired I