The power steering hose for my 91 GT needs replacing. I jacked up my
car crawled underneath with my wrenches only to find that I cannot
access the flare nuts at the rack and pinion. I have temporarily been
able to splice the hose with a new section but really want to fix it

My son has a 1983 Ford Mustang Convertible for sale. I believe the
block was cracked the other day. We quit driving it immediately. The
body has no rust, or dents. All original paint, and in pretty good
shape! Probably needs a new convertible top, this one is looking a

My '68 Coronet had the buildsheet under the rear seat when I purchased the
car. The original owner never knew it was there.
In researching my Data Plate on my '66 Mustang, the first field is obscured
somewhat and the first digit, or letter, is covered by the rivet.

'Check engine' light is on.  Auto technician ran computer diagnostic.  He
said the code showed the 'engine is running lean'.  The fuel filter and
PCV have been replaced, but we still get the computer code 'engine running
lean'. No visible vaccuum lines off.  Technician then smoke ...

I was thinking of replacing stock with flowmaster 50, I dont want it too
loud and do not want the drone,
I think the Flowmaster 40's are too loud for hte neighborhood.
Any quiet type aftermarkets out there?

Summary:
Whatgas- mileage difference will I see with a move from a 2.73 to 3.72
ring-and-pinion gear ratio in my '94 manual trans GT 5.0 liter?
Details:

The annual auto show hosted by Valley Forge Mustang Club...
http://www.tfrog93.com/events/vfmc/052707.htm
dwight

Is there a difference between the core units of 69 & 70 Rimblow
Steering Wheel?  I've managed to get hold of a 69 Rimblow and would
like to replace the 69 pad with a 70 pad (different inserts).  I'm not
doing a concourse restoration, but would like to have a "correct

Hi Group,
My wife's car has a slow A/C leak. We've had it at the dealer 3 times over
the past 5 years and they keep telling us that it's fixed, yet every spring
I have to recharge the system.

My 96' GT has 109,000 miles on it, and I am going to start putting
royal purple motor oil in to it. What weight should I use? 10W-30,
10W-30, and I even heard using 5W-20 is okay.

Would it be worth the issues/costs of converting a 4 cyl to an 8 cyl or
just buying the 8 first?
89 Mustang LX.
--

Help-blown head gasket? 67 FE Mustang
I think I have a bad head gasket. Here's what is happening:
          Starts up normally, runs well for about 15 minutes then it
starts to run rough, almost like an ignition miss. I've gone through

93 Mustang LX covertible top-how much to replace by a shop?
Anyone have a top done recently? I'm getting some estimates that
seem way too high to me.
Thanks

Does anyone know what to use to glue the side window in a 69 fastback.
Also would like to know the correct procedure.
Thanks,
Wendell

I have a '94 Mustang coupe. I'm about to try to install a subwoofer and
power amp in the back and of course I have to run a couple of wires for
power, etc.  from under the hood to the trunk. On past cars I've run them
through the firewall with no problems but on this car I can't ...