I went to the Homestead Miami track this past weekend to watch the
PBOC Motorsports Club have their points races and drivers school.
Apparently the club started out with just Porsches and Beemers but
there were lots of 'stangs in attendance.

I have a 2001 Mustang GT.( auto trans ) I have a CAI and SLP Loudmouth
Cat Back Exhaust so far. Now I'm looking for the best Under Drive
Pullies. There's so many choices out there. STEEDA, BBK, FORD RACING, &
etc. Aluminum or Steel?  Which ones will work the best with no ill

The shoulder harness on my Mustang gets tighter and tighter and tighter;
it never stops getting tighter.  I have to pull slack into it about
every 10 minutes.  They replaced the reel under warranty but it is only
slightly improved. None of my other cars do this.  Any one else have

Before my Internet Explorer died on me, I have several websites that
stated you can take the power steering unit out of a 80's model tempo
or tauras and bolt it into a 67 mustang. Does any one have this
information? I'm in desperate need to find out if this is true. I

This may be a dumb question, but I tend to be unlucky, so.....
I have a '94 Mustang 3.8 v6, and it runs hot when driving in stop and
go traffic for longer than 15 minutes.  The thermostat seems to be
operational because the temp gauge goes back and forth.  Today, the

i own a 68 mustang.  i am trying to locate rear seat foam for my
mustang.  is there a site i can go to purchase a set?

Pretty cool...
---
American Racing Equipment has long been a cornerstone of hot rodding
and racing, beginning with the company's development and introduction

Anybody recommend one for a fox car?  Looking for everything - unibody,
suspension, drivetrain.

I have a 1989 5.0 LX convertible, with the T5OD manual transmission.
I'm beginning to wonder about the clutch.  There have been a few
instances recently where I have felt a surge, or what may be clutch
slippage.  Each time, however, has been in the rain.

A pretty impressive piece of hardware!
http://www.shelbysupercars.com/carspecs.php
Patrick

I knew it was only a matter of time.  Some foreign company was going
to enter the pony car market.  But what I never suspected was that the
company would be Hyundai.  I figured it would be Toyota since they've
been trying for years to steal the rights to Chevy's old ad campaign

I'm a new subscriber and I'm hoping someone can help.
I have a 1984 Mercury Capri RS 5.0 (Mercury version
of the Mustang GT) that has led a very sheltered life,
but the tires are wearing thin. The tires and wheels

Should the carb's linkage be lubricated or just
cleaned with a spray cleaner.  If lubed, what to use.
Had a hard time today kicking the car down from fast
idle after starting it.  Nothing has changed with the carb.

Does anybody know what would be a good and affordable brake upgrade
for a 5.0 fox body mustang GT?  I am looking into getting PowerSlot
rotors and some hawk pads but the rotors alone are $200 for 2 of them,
ouch!  I know there is some interchangeability between some of the

Can some one tell me how to take out a 6 cd changer  out of a 2001
msutang gt?