Trying to install a new distributor in the above truck 4.9l engine. The
problem here is
that the distributor flange wont seat properly against the engine block ( it
stops about 1/4 inch or so ).The gears engage with the camshaft . I've tried

I love my truck, but about five times in the 2.5 years I've owned it it
fails to start when warm, once or twice after very short drives. 1/2 hour
later it starts on the first hit. It's just about like clockwork, 1/2 hour
and no problems. I've had it into the dealer three times and ...

   Have 91 Bronco fullsize 4x4. The left upper and lower balljoints are
getting
 kinda sloppy. It has to be fixed in order to get an alignment. I was just
 wondering how hard it is to get the balljoints out. I have heard of poeple

I have the opportunity to pick up a Ford Lightning for 27k.
It is a brand new 2004.  I guess trucks are moving slow right now.  A local
dealership, and this dealership is kind of large, had a red tag sale last
weekend and sold only 1 truck off of the whole lot.

My '97 F250 HD has a set of 8 lug aluminum wheels on it; it's not the
"shinny" ones I've seen like OEM but has the same round holes in the
wheel body. I'm wondering if they are after marker. The rear hub says
"Modern" but I don't seem to fine a web site.  Some of the lug nuts are

Greetings and Salutations
    I've a 1990 Ford Ranger, five speed manual tranny, and the smaller 4
cylinder EFI engine.
    My problem with truck shudder is at highway speed (60-65) in fifth gear,

I have just purchased a new 2004 F150 Lariat and I'm having problems
with the A/C. I can select Max A/C but after about 15 minutes the
truck automatically switches it back to outside air. How can I stop
this, any suggestions.

I have a 1985 Ford Bronco 351 w 4bbl HO.
The AC was converted over to 134a and it blows
cold as can be. Except when you accelerate and the
rpms go over 3000 then it goes to defrost.

Looking for the new style (2002-2003) grill, center only. Anyone have one
they'd like to sell? LMK!
Thanks for looking,
SMC

I've got a 1980 Ford F-100 I bought new in 1980 with an inline 6 and no A/C.
It has always run in the "normal" temperature range until recently when it
started running right on the "cold" line of the gauge.  I thought it was the
thermostat, so I replaced that.  Now, when it's cold ...

Hi guys, need some advise on type of tire for my truck, I do mostly hiway
drvn w at most 300 pds cargo on the bed. Should I replace OEM All Terrain
tires w All Season ones? While I'm at it, how wide can I go from OEM
255/70/16 in order to increase stability. I was thinking 265/65/16 ...

I need brakes for my '92 F-250 diesel.  I see ceramic break pads - are they
better than smi metal.
Thanks,
RO

I had a Ranger 96 with a 4. liter  in it until I recently bought a new F150
crew cab.  The cruse control seemed to kept the ranger at a constant speed
even going down hill with out stepping on the brake most the time.  My new
F150 I have noticed doesn't kept the adjusted speed  very ...

I have a 1987 F250 with 351 4 barrel carb and auto transmission.
Drove it into the woods today on a jeep/logger trail (to cut some
downed trees)  and it would stall out when going over just about every
large bump(rocks, logs).

Do I even need to grease the front end of this truck?  I can't seem to find
any grease fittings.
Any advice?