I just got a couple of free, slightly corroded, but otherwise great
condition diamond plate tool boxes for my F250.
Anyone know what would be the best/shortest/easiest way to get them shining
again?

I have a 1999 Ranger with a 3.0 liter V6, A/C and P/S, two wheel drive. When
I run the engine it makes a whining sound. Removed the serpentine belt and
ran the engine, no noise. Turned the waterpump by hand and sure enough I
heard something. Question, is there anything strange or ...

I've got a '73 F250 with a 360 that will soon have to be rebuilt or
replaced. The 360 runs great but has a 9 mpg bad habit. I've heard a 390 is
a "better" choice. Mr. Gazzguzzler presently has a new C6 sitting behind the
360. My question is will a 390 bolt right up to that bell ...

I have a nice '96  F350 XL Crew Cab  that I enjoy driving.
Nech seats, no cnsole, so no place to set mycoffee in the morning.
I've loked at Pep Boys for a suitable cup holder of some kind, but nothing fits
the floor hump due to the angle.

I broke the review mirror on my wife's 2000 Explorer. I found a cheap
aftermarket replacement at a local parts store. But, I could not figure out
how to take the old mirror off of the metal bracket that is glued to the
window. There was a little nub, but no visible screws. I'd ...

Well, I just passed 100K on  my 1990 F150 4x4.  The front end is getting
sloppy and is starting to develop some clunking and some of the ball-joint
boots are torn, so I suppose it's time to overhaul the suspension components
and steering stuff.

1996 f350 crew cab.  interior is like a vegas brothel (red everywhere!).  id
like to change my color to black or another neutral color.  i know carpet sets
are available and seats can be recovered.  im wondering about the dash and
interior plastic.  is there any type of paint that ...

I recently raised my 86 ranger 2" and now i can see rub marks on the front
drive shaft where its been rubbing the front crossmember, does anybody know
of an after market crossmember, or maybe another solution to this problem.
Any advice would be apreciated.  thanx

I have a meeting on Deimos in 3 weeks and I want to upgrade my Ford to
travel from Earth to Deimos.
Is it possible to install a hyperdrive into a Ford truck and will the
space-police allow it or not?

I have a 1986 F-150 4X4, 4.9L six, 4speed ( what some call a " granny "
4-spd ). After a motorcycle accident, The clutch is quite painful to use (
doc says " live with it " ). What all will I need to convert this truck to
an auto trans. I know I'll need the trans, T-case adapter and ...

Buy it now ford 1964 truck on ebay.

While driving last night my Over Drive light on the end of my gear shift came
on. Normally that means OD is off. But after pushing the button on the end of
the gear shift it turned off and pushing again it went on. (Over Drive not the
light) But the OD light is still on even though ...

By far the finest site I have come across, thought I would share it with you
gearheads and week end mechanics.
http://dodgeram.org/tech/repair/
ttys

1996 f350 PSD, has a big APC mounted under the dash (right where id like to
mount my cb radio!).  what purpose does this serve, is it something i can use
as a regular joe, and what would happen if i unplug it and remove it?
thanks!

Anybody know of a source for replacement/reproduction emergency cables
for a F100 long bed?
Thanks, John