I've run across a '38 pickup for sale which a friend,who knows a little
about the truck, says has a '48 engine (I haven't had the opportunity to
look under the hood).  In any event, before I become too serious about
this truck, are body/interior parts hard to find?  Have a lot of ...

Been thinking of putting a CB antenna on the `04 Ranger. But I think the
tolerance between the engine cover and the fender are a bit tight for the
coaxle cable. And The hood bracket is different than what you would find on
a full size truck, it is way inside and has nowhere to ...

I have a 2002 F-150 SuperCrew. (FX4, air, etc...). I also have a small
commuter car. I live in Minnesota and I have heard varying opinions about
leaving my truck plugged in for an extended period of time (upwards of  a
week straight). My truck gets a lot of use during hunting season ...

I have a 2000 expedition with 65K miles. Its due for a grease job on
the front end. There are no grease fittings on the necessary joints.
How does one remove the plugs where the grease fittings should be?
Thanks for your help.

I have a 1998 F150 with an 862B axle (3.55) . Is there a way to tell if it's
limited slip differential?
Glen

I have a 97 PSD F250. In trying to get the dash out in order to get to
the defroster vents, BTW does the dash come out as a one piece unit?
Anyway I found a module that is the keyless entry receiver. Now the
manual has no reference to a keyless system for this truck. I am sure

Hey guys,
We have a 99 F250 powerstroke 4x4.
We just got it back from the shop for some repairs to the clutch master
cylinder and slave cylinder, the transmission had to be dropped to put in a

Several nights of work and I'm getting stumped here guys. I'm gonna
tray and describe my story a little better to see if any ideas come to
mind,
I found a Bronco sitting in a driveway and it was for sale. The guy

It is too cold and wet to look for myself right now, but am wondering if
anyone has accessed the fog lamp switch on an `04 Ranger.
I was thinking, it is off on the passenger side of the stereo. If I accessed
it, I could wire it up to the fuse panel, onto a circuit that is ...

Hello all you Ford Enthusiast. I just recently aquired a Ford SVT
Supercharger, and I am trying to find out what engine its for. I have some
numbers off the back of it, they are as follows. Please any information you
can pass my way would be very appreactied. Thank you

Hello..
My name is Kristjan and I live in a small country called Iceland. (It's in
North Atlantis.)
I just wanted to show you the first photos of my 49" Ford.

Where else might it leak from? I had the same problem and replaced the
hose on my 97 PSD, it was the easist one I have ever replaced BTW. But
I still seem to have a leak. I havn't had time to wash it off
underneath yet, but when I do, any ideas where I should look first.

Novice hear.
1997 Expedition has heat in the rear but nothing but cold air in the front.
Any suggestions are where to start looking for the problem?
Thanks

Need to replace this.  Want to do it myself. Not sure if mechanical enough.
Have done timing chain on another vehicle. Done brakes, calipers, tie rod
ends, shocks, fuel pumps, water pumps, radiator replacement and plenty of
misc.  I understand that the dash has to be pulled out.  I ...

Today, I started the truck, ('99 SuperDuty PSD 7.3) let it warm up about
3mins, and started up the road at a normal (easy) pace. Started up a slight
incline, and suddenly lost most of the power, the truck started slowing
down, the service engine soon light came on, and the truck ...