I have an ’01 Navigator with the 300hp 5.4 V8 in it. It was running
great until I took it in for an oil change 4 months ago and the thief
at the shop showed me a greasy air filter which he claimed he took off
my car. I knew he was F.O.S. but I went ahead and had him put a new

I was driving on the highway at 60 mph , the i heard a hissing sound and a
bang after that my truck dint have no more gears working....i could put it
in 1st to 5th and let go the clutch and nothing would happen , i then tried
to put it on 4x4 low ( without my front hubs engage ) ...

I am getting to buy a used topper for my truck.  My truck is a Mazda
B4000, which I understand is the same as a Ford Ranger.  Does anyone know
if a topper made for a Ford Ranger will actually work with the Mazda? The
Ranger topper in question is for a 97 Ranger with standard bed (6 ...

im having a problem just recently i was driving down the road and
coming to a stop sign and when im nearly stoped my truck feels like it
starts grinding  underneath then jerks and stops is this my transfer
case? my brakes work fine and it does not jerk in reverse.

I just bought a 1988 Bronco II that has very noisy valves.   Its a 2.9
engine with 127,000 miles.
I think the previous owner drove it like this for a long time without
getting this fixed.

My 1990 F150 5.0 4x4  (110K Miles)  has this annoying habit of losing all
spark and either not starting or stalling in traffic.  I pulled the coil
wire from the dist and I get no spark.  Where do I begin to diagnose this
problem??  Are there any common items for this generation of ...

Hi All: Have 2005 f150 that has specs rated for 6100 lbs towing cap.
Factory tow package is stamped with 5000 lbs max weight, 9900 lbs
distributed.
Heres the question: I want to rent a vehicle trailer (4 wheels) to tow a

I drive a 98 Ford Ranger all day, it has 266,900
miles on it, rebuilt engine, trans, new a/c , and
before all that work and now, when I start it up,
after 30 or seconds, it emits a five tone tone

Had a cruise control that went slowly bad.  Now doesn't work at all.
Manuals seem to avoid the issue completely.
Anyone have some guidance?
Thanks.

I am looking for any infos on setting the vacuum control for advanced
timing on a ford 460, 1986.
Any clues ?

Whats the procedure to remove my broken ignition key tumbler on my 1990
F-150?  Do I need to remove the steering column and disassemble
everything?  Or is there an easier way?  It's getting to the point where
you really need to twist the key really hard to get it to turn over.

Can anyone tell me if the speedo in my 2002 F-250 Superduty can be
re-calibrated for 35" tires.  When I had my 33" tires the speedo was correct
as I verified with my GPS system.  I would rather not splice into any wiring
if at all possible.  Thank you for your information.

I got this '87 4x4 ranger w/140k miles from my mother-in-law. She was the
only one to drive it, and seems to be a fairly good truck except....
   It has the 2.9 V6 EFI, which does not seem to be able to get out of its
own way. In 4wd,both high and low, it seems to do a very good ...

Asking those more knowledgeable than I, I pose the following...
The 'Auto Zone' diagnostic trouble code was for the coolant temperature
sensor. Although the check engine light has not reappeared, I have notice a
slight decrease in mileage, the tailpipe looks light it's running a ...

I have a 1999 ranger 4x4  4.0ltr  5spd and it idles fast (between 1500 and
2000 rpm) for 10 seconds or so after clutching it at stoplights / stop signs
etc
Theres not much consistencey though, it idles high at different rpm for