1995 Ranger XLT Supercab 2WD
60K miles
2.3 L, 5-speed Man.
Here’s a problem that I’ll no doubt wish I would have dealt with a

Hi Guys, I have an '87 Ford E350 with a 460.
Would like to install a vacuum gauge but am
getting conflicting advice on where to tee the line.
I was told...the PCV line?

Please indulge me.
Some time ago I owned a Ford 3/4 ton 4 X4.
Reg cab,390...4 barrel, manual floor shift and manual locking hubs.
That truck was very nice.

Hi.  Looking to find out what aftermarket fuel gauges will work on this
truck.  I ended up replacing the fuel tank last year because the original
sending unit was not working.  A buddy of mine had a tank with a working
sending unit in it, so I just switched tanks.  Now, when I ...

I am looking for info on what transmissions will bolt up to the current
engine in my 1983 F-150.  The engine is a straight six 300, 4.9L and
currently the transmission is a 3 speed automatic.  I do not know the
specific transmission number, but I can try to find it if needed.  I ...

I did a google search and nothing.  Look at PepBoys, etc.
Any good suggestions?
thanks in advance
Simon

I have a 2001 F250 S.D. 2 wheel drive. Recently I have been getting a
violent front end shake around 50 mph. Thought possible either out of
balance wheel/tire but changed and still have the problem. My next thought
is tie rod ends. I am still looking for other sugguestions.

A Dodge dealership where I bought my used F-150 offers oil change service
where I only pay for parts. However, they put in 10W30 oil in there, while
the engine requires 5W20 according to the manual (it's 4.2L V6). When I
brought this up with the floor manager, he said it's ok, ...

I was doing about 70 on the freeway when my bronco decided to quit.

odometer
(assuming 112 ) it(the engine) just stopped as if someone had turned it

This is going to sound like a silly question - but where is the radiator cap
on a 1999 F150 5.4 engine?
I've noticed a slow radiator fluid leak on the ground, and I want to put
some stop leak in the rad.  The fluid instructions say not to put in the

I just got my first F150! '05 Supercrew, leather heated seats, auto start
(I'm in Alaska), 4X4, gorgeous. I've waited a long time for this!
Aurora
remove the argo to reply

Hey Guys, i have a 1990 forf f-150 with the e4od tranny. I have a 331 stroker
im putting in the truck and i want to go to a carb and discard the EFI .  do
i have to do anything special with the tranny???????????

Does anyone have the memory map for the 2005 F150 5.4 L ECU?  I am looking
for equipment to read the ECU and make changes to the rear end ratio, fuel
to air mixturesa etc.
TIA.

just bought a pre owned ranger 2003 xlt.very clean with 40 thou miles on
it.im very very happy and have ordered a matching cap to.being a
previous owner of a 84 chevy s10 i learned as the truck got older the
little quirks and break downs.are there any ranger problems i should be

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=4556128305&rd=1&ss
pagename=STRK%3AMESE%3AIT&rd=1