Just replaced the clucth (etc.) on my 88 Ford Ranger, 4speed manual
transmission.  Now I can't seem to figure out how to bleed the lines.  There
is a bleeder at the top of the trans next to the hydro line, but I cannot
get a wrench or socket on it becasue of a pin (?) between the ...

I have a 97 Ford Ranger Ext cab, and when I got home tonight, my headlights
won't turn off! The ignition is off, manual light switch is off, but no
matter how long I wait, the headlights stay on.  I can pull the lever back
to put the high beams on, but pushing it forward to lock ...

1988 Ranger with manual trans. with hydraulic "slave".  Son bought this
truck with a bad clutch, turns out clutch was recently changed but sat for a
while and was slipping badly.  Removed trans, cleaned the animals out of
bell housing, but my son helped me by removing spring and ...

I've analyzed the EPA's fuel efficiency statistics for 2006 and posted
the top ten most fuel efficient cars in four categories (overall,
mid-size car, American vehicles and trucks) at
http://www.infozak.com/carmileage.html.

MY BRAKE PEDAL GOES TO THE FLOOR VERY SPONGY HAVE TO PUMP TO STOP. I HAVE CHANGED PADS, BLEED BRAKES FRONT AND REAR, THERE ARE NO LEAKS. EVERYTHING SEEMS TO WORK. ALSO THE BRAKE FLUID WAS BLACKHAS BEEN CHANGE
--
pooodaman

I have the 2003 F250 with a 6.0 liter Power Stroke with the tow/haul feature
on the tranny. (crew cab, 4X4)
I have noticed that after I've towed all day (fifth wheel) using the
tow/haul setting,  it seems like the tranny, after I've unhooked and an

91' Ranger. Corrosion caused a line failure in the rear of the truck
and I ended up replacing everything from front hookup(proportioning
valve?) - lines, hose & cylinders. I used prebuilt lines so I only had
to bend not flare. This vehicle had 1/4 inch components and 3/16 line

Truck has 30,000 orig miles,had truck since 26,000 miles,clutch went
bad.
Did not resurface flywheel,just new clutch disc and got about 1000
miles outta it.

I need to replace the retainer clips used on the sides and top of my 1989
F250 pickup windshield to hold the exterior windshield molding. The Ford
dealer couldn't locate them on their parts diagrams, much less supply a part
number.

Still having intermitant start up problems with my 94 ranger when warm. My
buddy says
I need an ignition module which is not cheap.Any opinions. What can a
failing ignition module do?

I have a dark blue ford van and I don't want to go to all the trouble of
fixing scratches properly, the van looks pretty good, and its a work truck
anyway.  However I have noticed that if I just hit the slight scratches with
an ordinary permanent black marker they essentially ...

It starts up cold every time. However sometimes
after stopping at the gas station  or running errands it won't start.
The starter turns over but it just won't start.
Just waiting for a while is all that helps. After replacing the battery

   Hiya, all,
   Just got an '04 F-150 a few weeks back and I was wondering about
something I read in the owners manual which I'd never heard before.
   Ford advises against using the cigarette lighter outlet as a power point

A beautiful New England morning ruined by white smoke.
40 degrees, truck fires right off after sitting 3 days.  White smoke.
Wait a minute for it to get some heat in the heads, White Smoke.
Seems a little noisier than normal, white smoke.

I have Rebuilt the engine & transmission & my truck now wont move front or
back. I'm trying to get so help to figure out the problem. If anyone wouldn't
mind giving me a hint to the solution, it would be very much appreciated.
Soto