| Thread | Last Post | Replies |
|
| PCM Question........ | 31 Mar 2006 23:49 GMT | 6 |
Do PCM`s go bad on a 1988 Ford F-150 4.9L? I believe mine is no good. Thanks, ...mfat
|
| 1994 ranger ??? | 31 Mar 2006 20:55 GMT | 3 |
4 cylnder 5 speed i had a new clutch .presure plate -throwout bearing put in 4 months ago/ did not change slave cylnder...any how now every 3 weeks i must bleed the clutch ..seems there is allways a air bubble at the slave ...there
|
| 06-F350 - 29 gallon tank | 31 Mar 2006 06:47 GMT | 5 |
not sure why ford placed only a 29 gallon tank in their f-350 diesel. Any recommendations on manufacturer for increasing the fuel capacity. I assume it will require an in-bed product as an extra tank? Recommendations welcomed with approx. prices paid including install.
|
| 94 150 1/2 ton air bag light & under dash buzzer & how to deactivate? | 30 Mar 2006 00:27 GMT | 7 |
I have an old 150 ford that I drive once every 2 or 3 months with over 203,000 miles on it. For some reason, even though it has never been in a front end crash, the dash air bag light is now on and a buzzer hidden somewhere under the dash goes off 3 times periodically. This low ...
|
| How come southern guys are such sissies? | 29 Mar 2006 15:57 GMT | 2 |
There were major fights everyday in the big city schools I went to outside of the south. There are hardly any major fights in any southern schools I know of. Are you guys afraid to fight? What is it about you that you think is tough?
|
| Master cylinder replacement and brake woes, F350 | 28 Mar 2006 16:05 GMT | 7 |
I have a 99 F350 Super duty, 4 wheel drive, V-10. Purchased the unit used and immediately had to do brake work on it as the brakes did not enough stopping power and the ABS light came on even after replacing the rear ABS sensor (there is only one ABS sensor on this truck). I ...
|
| Oil Pressure Sender-Special Socket? | 28 Mar 2006 12:32 GMT | 1 |
1986 F-150 w. Windsor 351 Gauge is showing low to no oil pressure-I want to check/replace the sender. Do I need a special deep socket? While showing no oil pressure on gauge, coolant temp is normal, engine idles
|
| Do you know what size the exhaust manifold bolt is for a 1990 F-250 460 ci? | 28 Mar 2006 03:41 GMT | 3 |
It's the rear bolt (not a stud) on the right side. I was told that it's 3/8"x 3" long, but I don't know the thread size. The sucker is busted off in there,so I'm going to try to EZ-Out it. Any tips on doing that would help to.
|
| 94 Ranger Stalling while driving | 28 Mar 2006 01:40 GMT | 2 |
94 Ranger, 2.3 L engine, 5 speed manual trans. Stalls while driving. I can drive it around for some time and without warning stalls, like it ran out of gas. Everything electrical is still on, radio, and lights. I've tried to pop the clunch, or start it while still rolling and it
|
| My 94 Ford Ranger | 27 Mar 2006 20:18 GMT | 9 |
I have a 94 ford ranger and i want to know what is avg. MPG because i get about 15 MPG or less. The truck has a little 4.0 V-6 auto with 130k. If I put camper shell on how will it affect my mileage, will it go up or down? if so by how much.
|
| 91 f150 towing capacity | 27 Mar 2006 02:00 GMT | 15 |
got a 91 f150 4.9l efi 4x2, recently had aod tranny rebuilt w/ heavy duty torq conv installed. any ideas what my towing capacity would be? wanna get a travel trailer.
|
| oil pressure | 26 Mar 2006 18:12 GMT | 6 |
I have a 95 F-150 6 cyl 4wd and I had a problem where the oil pressure went low. I had the oil pump replaced about a year ago so I don't think that is the issue. Does anyone have any guesses at what it can be? I had the truck towed home and would like some advice before I take it ...
|
| How do I check oil pressure? | 26 Mar 2006 15:45 GMT | 4 |
The guage on my 99 Ranger doesn't move when I start the engine. After driving a short distance,it registers normal. Where is the sensor located,so I can disconnect it to install a pressure guage and check it when the engine is first started? Thanks
|
| 351W crossover pipe for 81 E150? | 25 Mar 2006 06:58 GMT | 6 |
My 81 E150 w/351W needs a new crossover pipe, which I'm told is no longer available. The pipe and the converter were separate. On the 82 & up to (?) the converter is a part of the crossover pipe, sold as a unit. Will this fit my 81? Has anyone had experience with this situation?
|
| 92 F-150 rough idle, dies when put into reverse | 25 Mar 2006 04:29 GMT | 4 |
I just discovered this group and I have a problem I could use some help with. I did a quick google and I see I first need to go to the parts store and see who does the free OBD check, but...
|