My 83 f-100 needs a flexplate replacemnet which means dropping the
tranny.
What else should I plan to replace while its all tore down ? Seals ?
Gaskets ? Anything ?

I have a 2000 Ranger 2.6L 5 spd that idles too low, it used to idle fine
then started getting lower. Occasionally it's normal but more often it's
low. Cold start it's low enough to stall, warm is not much better. Someone
said I might clean the Mass air flow sensor( I think that's ...

The engine is a 4 liter.The problem is very intermitant
so I cannot take it to a shop. The danged thing finally acted up at my
buddies house so he got to test it. He put
his timing light on it and the timing light did nothing. The

I have a 2000 Ranger 2wd.  Most of the time I have to really fight with
the stick shift to get it into 1st gear.  If I am rolling just
slightly, it usually slips into place without too much pressure on the
shift stick.

Anyone ever rebuild a Ford Transmission with success? I have quite a bit
of automotive training , and even delved into automatic transmissions..
however when it came to Fords we never got into one , because my
automotive instructer told us they were too complicated . Chrysler 727s

I'm replacing the 02 sensor in my '96 F250. When I went to the local
NAPA store, the counter guy said I needed 2. I know where the one near
the cat is, that's the one I'm replacing, but I cannot see or find any
other 02 sensor on this truck. By the way, its a 8600+ F250 w/5.8 if

Truck: 1989 F150 Ex Cab 351- V8 - 5.8 Liter EFI - dual tanks - 2WD
190,000 miles.
Problem:  The truck starts and idles fine - most of the time.
(Yesterday it was a bit muggy and it took a little time to get it to

"Ford Designed The Ranger To Appeal To Girls and Young Women"
This is something I hear occasionally from people that own other
brands, and even some F-series owners.  Immediately I want to just
dismiss it as the old, tired, worn, Ford vs. Chevy vs. Dodge vs. The

Where is a good place to get new ORIGINAL type weather stripping that goes
around the doors for restoring my 1988 Bronco II ?
I may use JC Whitney but are there any others that might be better for this?
thanks

Noticed all of a sudden after making a pass on the freeway. Pressure
gage was fine for a few min's then proceeded to drop to zero and just
flack out. I stop and turn off the motor for 20 sec and problem gone.
So I thought. New filter/oil/ sender is still does it. High RPMs

My '94 Ranger didn't pass emissions inspection because they said it's
supposed to have an Exhaust Gas Recirculation System but my engine just
didn't have that component on it anywhere. They said it's probably
because a previous owner must have changed out the engine to a

44,000 mi on E350 superduty 5.4
Check Engine light just came on.
I do my own maintaince.  Bought used from dealer with 29K.
Engine runs, fluids good.

I purchased this truck about a year ago and immediately had a problem with
poor braking and the ABS warning light coming on. I had a shop test the ABS
system and they told me I needed a new sensor.  Replaced rear ABS sensor
(this is the only one on this model) right away and ...

Got a good one.  When I run my air conditioner the vents will switch from
panel to defroster.  This occurs when I press the gas pedal.  When I let off
the gas, the air switches back from defroster to panel.  Anyone know how to
fix this?

does a 1993 Ford Ranger 4.0L have a timing belt?
i am having trouble with my truck with a sqealing, squeaking noise and
it has died a couple of times even with the belt taken off and was
thinking the timing belt needed to be replaced but i was told that this