Hello everyone.  Ok here is the deal.  My 93 Ford E-150 with
a 300 six cylinder used to get close to 20 mpg on the highway.  I am
not sure what it got
in town.  Recently I had a new fuel pump put on.  The repair shop told

I have a 95 Ford Aerostar. The engine had bad motor mounts so I replaced
them with ones I got at Advance auto parts... well I was shocked...
literally The Vibration was 10 times worse then when I replaced them.
The Vibration in the steering wheel was horrible.. it did die down

I have a 94 Ford Ranger that makes a loud groaning sound (from the
wheels/axle area, not the engine) when I'm backing up in the morning. It
sounds to me like wet brakes, but it makes the sound when it's not wet
and I'm not braking. It's quite loud in the cab. Anybody know what's

I got rear-ended a few weeks ago in traffic and the impact broke the
two bumper brackets welded to the two-hitch, the ones underneath the
footwell where the license plate is mounted.  You can't see the bolts
with the footpad installed.

I have a 02 Winstar with a 3.8L engine light is on checked codes they read
181,7e5,and 401. Checked and cleaned egr port (not that dirty).According to
Haynes manual the 181 code is for engine fuel temperature sensor fault. The
manual only refers to the code but does not show or ...

Is there any reason you can't convert a reverse flow cooling system on
a Ford 302 to regular flow?  To make a long story short, a simple water
pump replacement turned into a timing belt, timing gear and timing belt
cover replacement too.  I didn't realize it but Autozone gave me the

I need to remove the driver seat on this and I'm trying to determine
the size of the Torx bit I need to remove the seat so I can service the
power system.  I don't want to strip it, and it is pretty tight in
there.

I have a 84 E 350 Motor Home with an 460 7.5 engine.  The problem I was
diagosed with, is one mechanic told me my exhaust valve guides were
worn out, and needed to be replaced. He came to that conclusion after
doing a compression test.  He also told me it would run around

How will I know if these need replacement? I've noticed a slight
vibration or intermittent noise at slower speeds for about the past
10,000 miles (I'm at 71,000 now). The other day a guy at the shop
suggested that the ball joints should be replaced "soon." I assumed

I have an 04 Ranger with a rack to carry sheet materials for my business.
Some sheets come in an odd sizes of 51x100 inches. With the rack I bult, I
can carry this easy. Problem is, I would like to haul a couple thousand
pounds at once. I've done 900 pound in the Ranger with no ...

I've worked on this truck since 1998.
Please visit: Ford Truck World
                  http://www.fordtruckworld.com/AmericanBLUZUMR
List of products used in this build up.

i have a 1998 f-250. my 4-wheel drive will not engage. the shifter will be in
the correct position and the 4-wheel indicator will come on. is there
something electrical or vacume opperated that inables it to engage?

Hello to group.
94 Ford Ranger 3.0 V6. Headlights flash on and off. Only the headlights,
instrument panel and park lights don't go out. Then I'll lose the lights for
a short time until I pull handle back for high beams and they come on. What

EMAIL ME:
CHICAGO-PIG@WEBTV.NET
OINK OINK

How to find a place to park.
Supposedly true, this is the way I understood the story.
While on her deathbed the much
loved Sister Mary Francis asked the people