I have some questions if you guys could help me. First, I'm from Europe, so
my english could be pretty bad. Second, because I live in Europe, I don't
have any wracker where I could buy a spare parts or shop where I could buy
books, or spares, but I love american trucks, so I want to ...

My 2002 2.3 liter Ranger is normally dependable, but recently it will not
start.  It cranks quickly enough, gives a strong spark, but doesn't light
up.  The spark plugs are dry when I remove them, even if the accelerator is
floored.  I swapped the fuel pump relay, thinking fuel ...

Keeping y'all posted on my 95 Ford aerostar.. Engine runs good , but
still has a little miss and of course bad vibration...  
I have done a lot of work on it over the past few days. and heres whatI
have found.. I bought in inline spark tester that connects between the

I have a new to me 1998 F-150.  The rear axle pumpkin has no drain/fill
plug.  The bottom gasket area is damp and I don't know if much oil has
leaked out over time.  It leaves no drops on the garage floor...but how can
I check level?  And...how do you refill one of these?  ...

I have the wheels and tires from my 1999 F-350 Crew Cab 4x4 (new wheels
and BFGs). Will they fit on my new 2007 F-350 Crew Cab 4x4? In other
words, was there some kind hub change between 1999 and 2007? The dealer
told me that they wouldn't, that there WAS some kind of change in ...

Has anyone changed their own sparkplugs on an Escape ?   How hard was it
?..there's SO much plastic on top of the engine.

            A groundhog ate my spark plug wires. It's a 1978 Ford 460
engine. So basically I have no idea what post on the distributor goes
to what cylinder on the engine. Does anyone know the cylinder layout on
the engine block if I am looking at the engine from

i have a 1991 ford ranger 3 liter, how do i remove the fuel rail from the
fuel lines, there is a a small fitting at the end of the tube connected to
the rail that joins the tube and the fuel supply braided hose, how do these
separate?   tia

At first was hard to start, but will now start but idle poorly (almost
stalling, then smoothing out repeatedly).  Also lack of power on
acceleration.
I poured my monthly can of B-12 Chemtool into the gas tank a couple of days

I asked this question before , tho maybe I didn't state it right I have
a 95 Ford aerostar with a 3.0 and I have bad vibration... now this
vehicle vibrates when you go to start the dang thing it vibrates when
you go to accelerate it tho it does better after it goes through the

Ford's extralong Expedition stretched 15 inches
It took more than 70 years, but Ford finally has a competitor for the
venerable Chevrolet Suburban.
at http://www.washtimes.com/autoweekend/20060921-125226-7829r.htm

I have a 1989 E350 7.3L Diesel and i seem to have some glow plug
trouble. i have searched posts for glow plug problems but, while ive
found plenty of posts, havent had any luck on my prob. anyway here's
the

Does anyone know exactly where the little shift motor is located on a
1997 Ranger 4x4 truck?  I think mine is toast.
Thanks

The air bag light is flashing code 32, high drivers side air bag
circuit resistance, on our '98 Ranger.  The service manual explains
that, to avoid an unwanted air bag deployment, the battery must be
disconnected and at least one minute allowed to pass before working on

wondering if anyone knows what the drivability symtoms are for one of
these ? I pulled the codes ..and that is what it told me it was along
with a bad temp sensor it also has a EGR code but my Van does not come
equipped with one . its a 95 Ford Aerostar with a 3,0 engine.  other