| Thread | Last Post | Replies |
|
| Bronco II fuel pump | 18 Nov 2006 01:07 GMT | 2 |
I had to replace the fuel pump in my '87 Bronco 2, this cost me $129 and the tank was rusty, I was charged $75 to have it cleaned. My question is how much of this will Ford cover
|
| rolling idle / 2003 f-150 supercrew 5.4L | 16 Nov 2006 21:20 GMT | 1 |
Hello, I get a rolling idle after shifting to Park or Nuetral from Drive, any ideas on what I need to look at to correct problem? Thanks in advance.
|
| Tire Repair Question | 16 Nov 2006 01:24 GMT | 12 |
My left front tire on my 2005 F350 4x4 is losing 2 - 3 pounds of pressure a day. The set has 40,000 miles on them with about 6/32 inch of tread left. The spare is unused. Would you: 1. Repair the tire and put it back on a: the front, b: the rear.
|
| 2003 Expedition Window Regulator | 15 Nov 2006 15:09 GMT | 1 |
I have a 2003 Expedition, that my front drivers power window started making some noise, and then stoped. Took the door apart this weekend, and one of the cables on the regulator was broked. I assume that
|
| 1997 f-250 ignition problem | 15 Nov 2006 06:14 GMT | 5 |
My truck ignition switch has been touchy of as long as I owned the truck if you turned the key all the way it would not start if you snuck up on it slowly it would start or if you went past the magic point you could back up until it started. Once you knew what was going on it was no ...
|
| Brakes | 14 Nov 2006 23:40 GMT | 3 |
I have a 2000 f-250 super duty v-10 and had to replace the master cylinder. I tried bleeding the brakes and they are not holding pressure, especially when the engine stars up. Is there something I need to do diff from the usual brake bleed protocol?
|
| Locking hub question | 14 Nov 2006 00:13 GMT | 1 |
I have a 99 f 250 had auto/lock hubs converted to warn locking hubs,should I block the vacum lines to hubs
|
| Ok tire guys! | 13 Nov 2006 12:49 GMT | 1 |
My friend just blew out the 3rd Goodyear Marathon on his fiver. He replaced them with some Mex brand called Denman or something... I understand that only a couple of companies make ST (special trailer) rated tires, right?
|
| F-150 4WD | 13 Nov 2006 10:16 GMT | 12 |
Bought a well used '87. Need to remove and replace the drain plug in the front differential. I'm told it's just "free spinning" and can't be removed with a wrench. I'm pretty sure there's no fluid in the gears. What do I need to do to get that drain plug out and replace it? Thanks>
|
| custom horn | 13 Nov 2006 07:16 GMT | 3 |
anybody got any suggestions on a custom horn that can play short sound files? I want to have mine say D'OH! like homer Simpson, among other things. I know it's juvenile and rather silly, but it would be better than
|
| Trailer Towing Guide Question | 12 Nov 2006 19:09 GMT | 2 |
I have been reading the "Ford 2006 RV & Trailer Towing Guide and the F250 / F350 Super Duty Brochure". I am getting puzzled with some of the stuff I am reading. Like this about the F350 4X4, Diesel, Crew, Short bed, SRW, suspension:
|
| f150 problems? | 12 Nov 2006 05:51 GMT | 15 |
ok my fuel pump wouldn't kick on, so I thought it was the pump. So I replaced the pump and the tank and the fuel filter and put in a new switch on the dash, but my pump won't kick on. When I had it apart I made sure that everything was getting power and working properly. I
|
| Low-Idle 2000 Ford Ranger 3.0L | 12 Nov 2006 04:21 GMT | 1 |
135,000 miles and started noticing random problems with the cold idle. Usually fixed itself when I tapped the gas. No other funtions seem affected. No, the truck barely starts and i have to keep my foot on the gas. Once warm, it barely idles below 500 rpm. Also I notice a
|
| F150 locks | 12 Nov 2006 03:17 GMT | 1 |
Purchased a 2006 F150 STX 4x4 Super Cab Flareside... Love everything about the truck exept: I do not have power locks. I would like to add power locks, keyless entry, alarm, and remote start!
|
| 98 Mazda B4000 5spd hesitation/engine balance UPDATE | 12 Nov 2006 01:25 GMT | 3 |
Car starts fine and idles with a vibration / out of balance feel. When accelerating the truck feels as if one cylinder is not firing. I have seen this exact condition
|