One more time, one more question... then I'll leave you guys alone.
On this '87 F-150 I bought last fall there are manual hubs, a 4 speed,
and a transfer case shifter. Transmission and shifter seem to work
fine. The hubs are easy to switch in and out of "Free" and "Lock"

I am looking to buy a 1999 F350 2wd crew cab long box with the 7.3l
diesel and drive expedited freight hauling a dual axle trailer. The
trailers max load could be only 5000 lbs. I am considering a 3.42 gear
to improve mpg. Can any one tell me their mpg experience?

I just bought a 1989 Ford Ranger 2WD for $250.  Runs perfect, but
there
is major frame rust (rust-out) at the front driver side rear spring
mount.  The mount that attaches to the frame is holding only at one

My dome light(s) no workie.  They work fine with the ceiling switches but
don't come on when I open the door-any door.
I'm wondering if the dome light has a relay and it's location.  Since the
problem is not with a single door I'm suspecting the problem is elsewhere.

    I just bought a 2002 Ford Explorer XLT with a 4.0 liter engine. I
would like to know how fast I can drive the truck in the 4 wheel drive
high setting (highway driving)? I have never tried 4 wheel drive low.
I think the truck has a sensor that activates 4 wheel drive when the

Hi everyone, I have a 2002 Ford Escape, V6, 4x4.
I recently had new calipers, rotors and pads installed.  A few days
afterwards, the ABS light came up, and then, the brake light came
on..!

Odd problem. It appears that occaisionally the rear brake lights stay
on after turning off the engine and removing the keys. My first
thought is the switch that must be near the actual brake pedal in the
Windstar.

this one is driving me nuts, tried a replacement module, checked the
reluctor, checked the ignition switch, all test out okay . After
sitting a couple hours it will not fire with the key in the start
position, I let off and catch it it on the run circuit to get it

They are the brackets that attach the springs to the frame--other than
a dealer, where else can one buy exact replacements?  I do not want
the raise/lower kits, just the exact factory replacements.
Thanks in advance !

I have great front seats except for the fold up/down back for the center
jump seat.  It is totally trashed.  I bought a cover for it but find that
I'll probably have to remove the old cover completely to get the new one on.
Hence, it I have to pull the back out I might as well ...

Is there something wrong with my rear end?
I've been losing traction from standing starts in even the slightest wet
ground conditions; wasn't a problem in the past.  It's especially jumpy when
turning from a standing start.

My 95 Ranger has a problem that 1 mechanic and 1 transmission specialist has
not been able to figure it out. The Ranger is a '95, with 4L V6, and 4WD
with automatic transmission. Under certain driving conditions, the
transmission seems to go into neutral for no reason, the engine ...

After posting that I have NEVER, EVER had a problem with my 95 Ranger XLT 4
cyl 5 speed. My heater does not wok...sorta. It works but only with high
rpm's. I idle and it blows cold air. I assume it's a vacuum problem. Someone
point me where to look?

Texas is for trucks. One in four Texans drives a truck of some kind and one out of every six trucks Ford sells are sold to Texans. Ford, GM and Toyota all make trucks in Texas.
===
Just one of Today's Top 10 Consumer News Stories: http://www.ng2000.com/fw.php?tp=ford-trucks

I was wondering if anyone could help me out with a little question here.
For about a month now ever since the cold weather and snow has set in I
haven't started or drove my Lightning at all.
I was just wondering if it would it be a good idea to start it up and