I recently noticed my truck is making some noises and they seem to be
coming from the back wheels I hear a rubbing sound at times and some
other noises. The truck stops fine and no lights are coming on but it
is riding rough. Any ideas on what could be going on? Any help would

Went to put my 2001 ranger in 4wd last night & nothing happened, not
even the dash light. I checked the fuse in the dash but that's not the
problem. any ideas?
thanks......

This vehicle has around 200k kms up and goes well. But I'm pretty sure
the front wheel bearings have never been checked/repacked since the
vehicle was new. Early on I asked them to do it with a normal service
but something about the way the service manager confirmed that it had

My AC compressor clutch will not energize.  Fuse is ok, there is 12v at the
switch but not at the plug on the compressor clutch.  Where can I get an
electrical drawing showing the path for this circuit?  Have a repair manual
but does not show this circuit.

Anyone here who can help me interpret a 1979 F350 VIN number?
Literally every web site I've dug up about reading VINs refers to 1981
and later only.  Typing a 1979 VIN in gets an error message of `incorrect
format'.

I have a 1995 Ford F150 extended cab pick up truck.  My ABS light
starting flashing.  (it flashes 16 times) which in my Ford manual says
it is nothing major.  I parked the truck in my driveway and now can
not get it out of park.  Anyone had any similar problems with this.  I

I have a ford F150, 1991, and after replacement of a broken belt
tensioner it became obvious that the belt tensionr alignment hole is
wor  out causing the tensioer to move back and forth.  I have called
several places and have been told the part is not available.  Is there

just got back from looking at the F-150 that I posted about earlier...
good: straight, rust free body, only surface rust on frame and
driveshaft.  Could easily be detailed underneath in a couple weekends.
Only cosmetic issue is a slightly tweaked rear bumper, apparently caused

My 97 Ranger does the following, always only when it is hot.  It does
not want to go into ANY gear, but if you rev up the motor and let off,
you can feel it "slip" into first gear if you maintain pressure on the
stick while holding the clutch in.

97 f-250 3 doors 4 wheel drive.  Im having a problem with the door adjar
light on dash staying on. after numerous attempts to shut doors and keep
interior lights out, I finally given up.
The fuse in #14 on panel, but I loose all power accesories as well.

I have a 1995 f-150 pickup with a 351 5.8L V8 engine, automatic
tranny, and there is a switch on the kickpanel close to the parking
brake. when i switch it, nothing noticeable happens, i thought it was
the fuel reset switch but that is on the passenger side, it is just a

Sorry for the tag line but I am litterally at the end of my rope
here.
I have a 460 from a 1988 F250, which has about 35K on a rebuild.
Let me start off by saying I use this truck about 5 times a year to

My 1999 Ford Ranger 4x4 has been exhibiting strange temperature
behavior lately. Normally, as the engine warms up the temp gauge moves
slowly up and stops in the center, and stays there. Recently the as
the engine warms the temp gauage moves up and continues past the

'81 F100.  I intend to have my truck repainted.  It's two-toned, but it
will be one color.  The paint place will mask the mouldings/symbols, but
I want to remove them.  A few pieces have nuts, but other pieces have
some kinds of different attachments.  The F O R D letters on the ...

I replaced a leaking valve cover gasket and I also intend to replace the
pushrod cover gasket.  (300cid/6cyl)  Over the life of this engine(27yr)
a build-up of oil/grime/junk has accumulated.  I used to pressure wash
it occasionally, but.....I slacked off some.  Any recommendations ...