Been lurking a bit whilst surveying the market for a used vehicle.  Didn't
plan on buying anything at this point in time, but a driver who lost
control of her vehicle in a late spring snow last Wednesday forced that
decision upon me. [@#$%!]

99 F-150, 2-wheel drive, rear drums.
I had to buy an entire caliper assembly just to get the mounting
bracket, cause one of my sliding mounting bolts was seized. Now I'm
stuck with a new caliper, since I changed the driver side 6 mos ago.

Hi Gang,
I have a 1999 motor home on an E450 frame/Triton V10 engine. After
sitting still for over a year the speedometer is going haywire. Engine
off it pegs over to the 100mph mark. Engine on, it drops back to 40mph

'99 Ranger 4.0L - After driving for a while (warm engine) the motor will
start cutting out (just for half second, enough to lurch a bit) somewhat
randomly. Someone suggested the plug wires were bad but I replaced them
about 5 years ago. Is it most likely the plug wires or what ...

2002 ford Ranger 4x4. front wheels pulse at slow speeds when brakes applied.
I thought it was the front ABS speed sensor. Disconnected passenger side and
problem goes away. Replaced sensor (costly replacement
$170 bucks) plugged in and problem returns. What else could it be?

I just changed the rotors and bearings on the front discs of my 99 2-
wheel drive F150.
The question I have is that one of the caliper mounting holes (the
ones that slide/and are somewhat springy) seems to be seized. Since I

My 4 Michelin 245/75r 16 tires are cracking around the rims and a dime size
piece of tire is missing from side wall on 2 tires. The web "tire rack"
recommends 235/75R 16. I pull a 27 foot 5th wheel severl times during
summer. Only off payment in a few upland camp sites. Any ...

My question is , Did my truck come with cats?  I have heard many
different answers to this question.  The sticker that was on the valve
cover has been rubbed off so I dont know if it did or not.  I had one
smog tech tell me that it is supposed to have them and where it is now

I am wanting to change the fuel pump on my 96 f150.
How would I go about doing this as I have never done this.

I have been getting BAD fuel economy with this truck.
11-13 mpg city whether its warm or cold out.
Highway is better at about 20-22mpg.
I can find no fuel leaks from tank or lines leading to carb.

I'm looking to add to my fleet, and I wanted to consider a mid- to late-'90s
F150. I notice that in '97, the latest year that I'm looking at, that the 6
cyl motors are the 4.2L V6. I think I want a '94 through "97 or '98 with a
V8 motor, but my budget may limit the options to a 6 ...

I'm not sure what the out puts are on the F150 lights for a 4 pin. I
can't get the running lights to work. I can get the turn signals and
brakes to work with the headlights on. Again, no running lights.
Please help.

Hey Gang,
Ive been getting estimates for getting a new motor put in my 99 E 150
4.2L van...I was told by one source that he could locate me a used low
mi. 3.8L motor and do the job MUCH cheaper than puttin a Jasper reman

Made the worst mistake.........$3200.00 worth!
Need a 302 5.0 litre engine for a 1990 Ford XLT.
Where is the best place to start?
How much should I pay, ect ....ect

What exactly shuts the engine off when you turn the key to off? And where is
it?
Al