Have a 93 Splash with 3.0 V6. Engine has about 100,000 miles.
Lately I noticed water dripping from the area where the tranny and engine
meet. So I refilled the radiator, started it up, popped the hood.  With a
flashlight, looking down from under the hood, near the rear of the engine ...

I have a former 1990 former U-Haul truck with the 7.3 diesel.   And (Yes new
relay) I think I have a bad compressor clutch.    Coincidentally, I just
happen to have one here in a box that is brand new.  However, being the
novice I am, and knowing that nothing is ever as easy to ...

Best Auto Repair Software / OBDII Code DB
Autotree Pro Ver. 1.45 is a 32 Bit ( WIN95-XP) software Application
for automotive diagnostics. The program written in a Tree format to
make systematic and quick diagnostic checks a breeze, organized by

This is the coolest truck box you have ever seen.  Check it out.
http://www.alumiknox.com

Hi again,
took the "new' truck to its first job yesterday, helping a friend
clean out a guy's stash of old car parts.  No problems at all until I
got to my first stop, when I shut the truck down it puked coolant

The truck is an '89 F150 4WD with 302 and a 5-speed manual
transmission.  I'm assuming it is the Mazda tranny (Mazda M-50D, would
this be R1 or  R2?), since I did find a picture of the ZF-5 unit and
that does not look right.  Mine doesn't sound like the typical Mazda

1995 Ford F150 6 cylinder 4.9L
My temperature gauge on the dash has been stuck on COLD for about a year.
The heater produces hot air no problem.  I changed the thermostat anyway,
but it didn't make any difference. So when my mechanic was doing some other

I am looking for a web site to help me choose the right size wheel and
tire for my '60 Ford F100.
I am looking to put on the thinnest whitewall tires I can. And I would
like the rear tires to be larger diameter than the front to get a

Does an E4OD have a lockup TC?  Owner's manual is silent on the issue.
Just curious.
thanks,
nate

Best Auto Repair Software / OBDII Code DB
Autotree Pro Ver. 1.45 is a 32 Bit ( WIN95-XP) software Application
for automotive diagnostics. The program written in a Tree format to
make systematic and quick diagnostic checks a breeze, organized by

I am lookig at a 1960 Ford F100 with Big Block 460, 750cfm Carter Carb
and a 410 ford 9inch rear end. The owner says it idles poor when the
fuel level is low. Can anyone guess what the real problem of the rough
idle is?

I have driven my F250 for about 50 miles and the ECU reads "Not Ready"
on my Scan Gauge.  I also an intermittent analog instrument cluster.
I took the cluster apart and cannot find any bad solder joints, so I am
using the San Gauge to read my speed, water temp, voltage, etc.